menu "Hardware Drivers Config"

config MCU_HC32L136
    bool
    select ARCH_ARM_CORTEX_M0
    select RT_USING_COMPONENTS_INIT
    select RT_USING_USER_MAIN
    default y

menu "Onboard Peripheral Drivers"

endmenu

menu "On-chip Peripheral Drivers"
    config BSP_USING_GPIO
        bool "Enable GPIO"
        select RT_USING_PIN
        default y

    menuconfig BSP_USING_UART
        bool "Enable UART"
        default y
        select RT_USING_SERIAL
        if BSP_USING_UART
            config BSP_USING_UART0
                bool "Enable UART0"
                default n

            config BSP_USING_UART1
                bool "Enable UART1"
                default y
        endif

    menuconfig BSP_USING_SOFT_I2C
        bool "Enable software I2C (swi2c)"
        default n
        select RT_USING_I2C
        select RT_USING_SOFT_I2C
        if BSP_USING_SOFT_I2C
        menuconfig BSP_USING_SOFT_I2C1
            bool "Enable software I2C1 Bus (swi2c1)"
            default n
            select RT_USING_SOFT_I2C1
            if BSP_USING_SOFT_I2C1
                config RT_SOFT_I2C1_SCL_PIN
                    int "swi2c1 SCL pin number"
                    default 51
                config RT_SOFT_I2C1_SDA_PIN
                    int "swi2c1 SDA pin number"
                    default 90
            endif
        endif
endmenu

menu "Board extended module Drivers"

endmenu

    config RT_SOFT_I2C1_HAS_PIN_DEFAULT
        bool
        default y if RT_USING_SOFT_I2C1

    config RT_SOFT_I2C1_SCL_PIN_DEFAULT
        int
        default 51 if RT_USING_SOFT_I2C1

    config RT_SOFT_I2C1_SDA_PIN_DEFAULT
        int
        default 90 if RT_USING_SOFT_I2C1

endmenu