menu "Hardware Drivers Config"

menu "Onboard Peripheral Drivers"

endmenu

menu "On-chip Peripheral Drivers"

    config BSP_USING_BDMA
        bool
        default n

    config BSP_USING_GPIO
        bool "Enable GPIO"
        select RT_USING_PIN
        default y

    menuconfig BSP_USING_UART
        bool "Enable UART"
        default y
        select RT_USING_SERIAL
        if BSP_USING_UART
            config BSP_STM32_UART_V1_TX_TIMEOUT
                int "UART TX timeout"
                default 6000
                depends on RT_USING_SERIAL_V1
                
            menuconfig BSP_USING_UART1
                bool "Enable UART1"
                default y
                if BSP_USING_UART1
                    config BSP_UART1_RX_BUFSIZE
                        int "Set UART1 RX buffer size"
                        range 64 65535
                        depends on RT_USING_SERIAL_V2
                        default 256

                    config BSP_UART1_TX_BUFSIZE
                        int "Set UART1 TX buffer size"
                        range 0 65535
                        depends on RT_USING_SERIAL_V2
                        default 0
                endif

        endif
    menuconfig BSP_USING_SPI
        bool "Enable SPI BUS"
        default n
        select RT_USING_SPI
        if BSP_USING_SPI
            config BSP_USING_SPI2
                bool "Enable SPI2 BUS"
                default n

            config BSP_SPI2_TX_USING_DMA
                bool "Enable SPI2 TX DMA"
                depends on BSP_USING_SPI2
                default n

            config BSP_SPI2_RX_USING_DMA
                bool "Enable SPI2 RX DMA"
                depends on BSP_USING_SPI2
                select BSP_SPI2_TX_USING_DMA
                default n
            
            config BSP_USING_SPI6
                bool "Enable SPI6 BUS"
                default n

            config BSP_SPI6_TX_USING_DMA
                bool "Enable SPI6 TX DMA"
                depends on BSP_USING_SPI6
                default n

            config BSP_SPI6_RX_USING_DMA
                bool "Enable SPI6 RX DMA"
                depends on BSP_USING_SPI6
                select BSP_SPI6_TX_USING_DMA
                default n

            # SPI6 BDMA (BSP_SPI6_TX/RX_USING_BDMA) is provided by the shared
            # HAL_Drivers Kconfig below, sourced for all STM32H7 series BSPs.
        endif
    source "$(BSP_DIR)/../libraries/HAL_Drivers/drivers/Kconfig"

endmenu

menu "Board extended module Drivers"

endmenu

endmenu