menu "Hardware Drivers Config"

    menu "Onboard Peripheral Drivers"

    endmenu

    menu "On-chip Peripheral Drivers"
        config BSP_USING_GPIO
            bool "Enable GPIO"
            select RT_USING_PIN
            default y

        menuconfig BSP_USING_UART
            bool "Enable UART"
            default y

            if BSP_USING_UART
                config BSP_STM32_UART_V1_TX_TIMEOUT
                    int "UART TX timeout"
                    default 1000
                    depends on RT_USING_SERIAL_V1

                config BSP_USING_LPUART1
                    bool "Enable LPUART1"
                    default y

            endif
        source "$(BSP_DIR)/../libraries/HAL_Drivers/drivers/Kconfig"

    endmenu

    menu "Board extended module Drivers"

    endmenu

endmenu