menu "Hardware Drivers Config"

menu "Onboard Peripheral Drivers"

endmenu

menu "On-chip Peripheral Drivers"

    config BSP_SCB_ENABLE_I_CACHE
        bool "Enable ICACHE"
        default y

    config BSP_SCB_ENABLE_D_CACHE
        bool "Enable DCACHE"
        default y

    config BSP_USING_GPIO
        bool "Enable GPIO"
        select RT_USING_PIN
        default y

    menuconfig BSP_USING_UART
        bool "Enable UART"
        default y
        select RT_USING_SERIAL
        if BSP_USING_UART
            config BSP_STM32_UART_V1_TX_TIMEOUT
                int "UART TX timeout"
                default 6000
                depends on RT_USING_SERIAL_V1
                
            menuconfig BSP_USING_UART1
                bool "Enable UART1"
                default y
                if BSP_USING_UART1
                    config BSP_UART1_RX_BUFSIZE
                        int "Set UART1 RX buffer size"
                        range 64 65535
                        depends on RT_USING_SERIAL_V2
                        default 256

                    config BSP_UART1_TX_BUFSIZE
                        int "Set UART1 TX buffer size"
                        range 0 65535
                        depends on RT_USING_SERIAL_V2
                        default 0 
                endif

        endif

    menuconfig BSP_USING_SPI
        bool "Enable SPI BUS"
        default n
        select RT_USING_SPI
        if BSP_USING_SPI
            config BSP_USING_SPI5
                bool "Enable SPI5 BUS"
                default n

            config BSP_SPI5_TX_USING_DMA
                bool "Enable SPI5 TX DMA"
                depends on BSP_USING_SPI5
                default n

            config BSP_SPI5_RX_USING_DMA
                bool "Enable SPI5 RX DMA"
                depends on BSP_USING_SPI5
                select BSP_SPI5_TX_USING_DMA
                default n
        endif

    menuconfig BSP_USING_PWM
        bool "Enable PWM"
        default n
        select RT_USING_PWM
        if BSP_USING_PWM
        menuconfig BSP_USING_PWM1
            bool "Enable timer1 output PWM"
            default n
            if BSP_USING_PWM1
                config BSP_USING_PWM1_CH1
                    bool "Enable PWM1 channel1"
                    default n
                config BSP_USING_PWM1_CH2
                    bool "Enable PWM1 channel2"
                    default n
                config BSP_USING_PWM1_CH3
                    bool "Enable PWM1 channel3"
                    default n
                config BSP_USING_PWM1_CH4
                    bool "Enable PWM1 channel4"
                    default n
            endif
         endif

    menuconfig BSP_USING_TIM
        bool "Enable timer"
        default n
        select RT_USING_CLOCK_TIME
        if BSP_USING_TIM
            config BSP_USING_TIM2
                bool "Enable TIM2"
                default n
        endif

    source "$(BSP_DIR)/../libraries/HAL_Drivers/drivers/Kconfig"

endmenu

menu "Board extended module Drivers"

endmenu

endmenu