tinyusb.git/hw/bsp/stlinkv3mini, branch 0.7.0 Unnamed repository; edit this file 'description' to name the repository. http://cgit.235523.xyz/tinyusb.git/atom/hw/bsp/stlinkv3mini?h=0.7.0 2020-10-30T07:14:28Z use cmsis 5 for all stm32 2020-10-30T07:14:28Z hathach thach@tinyusb.org 2020-10-30T07:14:28Z urn:sha1:a6efe475e7b68b5fbba371a1a73ecf474ef226c4 f7 use offical st driver repo 2020-10-30T06:20:09Z hathach thach@tinyusb.org 2020-10-30T06:18:56Z urn:sha1:b9ca7e91dff4861a4ca2c65f462b6b1cbf9e06cc change REDUCE_SPEED=0/1 to explicitly SPEED=high/full 2020-07-08T09:29:48Z hathach thach@tinyusb.org 2020-07-08T09:29:48Z urn:sha1:0fd074afd85d84f162ddebbc9b8e009f9136809b update readme, boards.md to add link to new stm boards stlinkv3mini: Only OTG_HS has connector. 2020-07-03T08:59:02Z Uwe Bonnes bon@elektron.ikp.physik.tu-darmstadt.de 2020-07-03T08:59:02Z urn:sha1:11c6d4cdaea007cbe804dfc7d512bd82562e41d2 STM32/OTG_HS: Allow OTG_HS port to run at FS speed. 2020-07-03T08:52:57Z Uwe Bonnes bon@elektron.ikp.physik.tu-darmstadt.de 2020-07-01T21:07:18Z urn:sha1:fd3817818921981aa67e1fb845f926c010444fea Add "REDUCE_SPEED=1" to the compile options. correct HSE_VALUE in hal_conf 2020-07-02T07:57:00Z hathach thach@tinyusb.org 2020-07-02T07:57:00Z urn:sha1:4cec866994f32f729844d0159e14c178f5aa904f - although it is define in CFLAGS, it is worth to correct to be consistent with other build - extract set_speed() change default port some stm bsp 2020-07-02T04:58:40Z hathach thach@tinyusb.org 2020-07-02T04:58:40Z urn:sha1:9a290febcdd7aaa50657f3d31da31bd493fa3a0e - f769disco default port is highspeed port1 - remove PORT0 on stlink since the board only populated HS connector Add bsp for stlinkv3mini. 2020-07-01T13:42:53Z Uwe Bonnes bon@elektron.ikp.physik.tu-darmstadt.de 2020-07-01T12:52:49Z urn:sha1:5b3a67a1e208296d927da31c3df1aefa562ec2ac