diff options
| -rw-r--r-- | hw/bsp/lpcxpresso51u68/board.mk | 22 |
1 files changed, 14 insertions, 8 deletions
diff --git a/hw/bsp/lpcxpresso51u68/board.mk b/hw/bsp/lpcxpresso51u68/board.mk index 21b6c55fc..98bef6758 100644 --- a/hw/bsp/lpcxpresso51u68/board.mk +++ b/hw/bsp/lpcxpresso51u68/board.mk @@ -1,4 +1,5 @@ -DEPS_SUBMODULES += hw/mcu/nxp/mcux-sdk +SDK_DIR = hw/mcu/nxp/mcux-sdk +DEPS_SUBMODULES += $(SDK_DIR) CFLAGS += \ -flto \ @@ -13,7 +14,7 @@ CFLAGS += \ # mcu driver cause following warnings CFLAGS += -Wno-error=unused-parameter -MCU_DIR = hw/mcu/nxp/mcux-sdk/devices/LPC51U68 +MCU_DIR = $(SDK_DIR)/devices/LPC51U68 # All source paths should be relative to the top level. LD_FILE = $(MCU_DIR)/gcc/LPC51U68_flash.ld @@ -22,14 +23,20 @@ SRC_C += \ src/portable/nxp/lpc_ip3511/dcd_lpc_ip3511.c \ $(MCU_DIR)/system_LPC51U68.c \ $(MCU_DIR)/drivers/fsl_clock.c \ - $(MCU_DIR)/drivers/fsl_gpio.c \ $(MCU_DIR)/drivers/fsl_power.c \ - $(MCU_DIR)/drivers/fsl_reset.c + $(MCU_DIR)/drivers/fsl_reset.c \ + $(SDK_DIR)/drivers/lpc_gpio/fsl_gpio.c \ + $(SDK_DIR)/drivers/flexcomm/fsl_flexcomm.c \ + $(SDK_DIR)/drivers/flexcomm/fsl_usart.c INC += \ $(TOP)/$(MCU_DIR)/../../CMSIS/Include \ $(TOP)/$(MCU_DIR) \ - $(TOP)/$(MCU_DIR)/drivers + $(TOP)/$(MCU_DIR)/drivers \ + $(TOP)/$(SDK_DIR)/drivers/common \ + $(TOP)/$(SDK_DIR)/drivers/flexcomm \ + $(TOP)/$(SDK_DIR)/drivers/lpc_iocon \ + $(TOP)/$(SDK_DIR)/drivers/lpc_gpio SRC_S += $(MCU_DIR)/gcc/startup_LPC51U68.S @@ -38,9 +45,8 @@ LIBS += $(TOP)/$(MCU_DIR)/gcc/libpower.a # For freeRTOS port source FREERTOS_PORT = ARM_CM0 -# For flash-jlink target JLINK_DEVICE = LPC51U68 +PYOCD_TARGET = LPC51U68 # flash using pyocd (51u68 is not supported yet) -flash: $(BUILD)/$(PROJECT).hex - pyocd flash -t LPC51U68 $< +flash: flash-pyocd |