| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2020-07-16 | add fs & hs config for cdc_msc_freertos, midi_test, msc_dual_lun | hathach | |
| 2020-07-16 | fix unintended changes to webusb example | hathach | |
| 2020-07-16 | add tud_speed_get() | hathach | |
| - define both fs and hs configuration descriptor - rename CFG_TUD_CDC_EPSIZE to CFG_TUD_CDC_EP_BUFSIZE with default size of 64 for FS, and 512 for HS | |||
| 2020-07-10 | Merge pull request #461 from CraigHutchinson/patch-1 | Ha Thach | |
| Improve comment on CDC tud_cdc_write_available() | |||
| 2020-07-10 | Improve comment on CDC tud_cdc_write_available() | Craig Hutchinson | |
| Fixes #460 | |||
| 2020-07-10 | Merge pull request #456 from me-no-dev/esp32-s2-epin-to | Ha Thach | |
| ESP32-S2: Detect EP IN Xfer Timeout | |||
| 2020-07-08 | Merge pull request #447 from hathach/add-stm-hs | Ha Thach | |
| Add support for STM32 OTG HS core | |||
| 2020-07-08 | change REDUCE_SPEED=0/1 to explicitly SPEED=high/full | hathach | |
| update readme, boards.md to add link to new stm boards | |||
| 2020-07-06 | correct EP Size for cdc dual and webusb example | hathach | |
| 2020-07-05 | Merge pull request #457 from UweBonnes/add-stm-hs | Ha Thach | |
| Add stm hs | |||
| 2020-07-03 | Add stm32l4r5nucleo. USB and UARTwork. | Uwe Bonnes | |
| USB runs from LSE stabilized MSI48 LPUART on PORTG needs VDDIO2 enabled. | |||
| 2020-07-03 | stlinkv3mini: Only OTG_HS has connector. | Uwe Bonnes | |
| 2020-07-03 | stm32h745disco: HAL_PWREx_EnableUSBVoltageDetector() is needed for hot replug. | Uwe Bonnes | |
| 2020-07-03 | stm32h745disco: Only OTG_FS is available. Does not enumerate on replug yet. | Uwe Bonnes | |
| 2020-07-03 | STM32/OTG_HS: Allow OTG_HS port to run at FS speed. | Uwe Bonnes | |
| Add "REDUCE_SPEED=1" to the compile options. | |||
| 2020-07-03 | update per review | hathach | |
| 2020-07-03 | fix NVIC disable typo | hathach | |
| 2020-07-02 | ESP32-S2: Detect EP IN Xfer Timeout | me-no-dev | |
| In some rare ocasions (bad cable, noise, etc.) data transfer might timeout and hang the endpoint, unless the interrupt flag is cleared. This pull request targets to solve that case. | |||
| 2020-07-02 | correct HSE_VALUE in hal_conf | hathach | |
| - although it is define in CFLAGS, it is worth to correct to be consistent with other build - extract set_speed() | |||
| 2020-07-02 | change default port some stm bsp | hathach | |
| - f769disco default port is highspeed port1 - remove PORT0 on stlink since the board only populated HS connector | |||
| 2020-07-02 | clean up | hathach | |
| 2020-07-01 | Merge branch 'add-stm-hs' of github.com:hathach/tinyusb into add-stm-hs | hathach | |
| 2020-07-01 | Merge pull request #455 from UweBonnes/add-stm-hs | Ha Thach | |
| Add stm hs | |||
| 2020-07-01 | Add bsp for stlinkv3mini. | Uwe Bonnes | |
| 2020-07-01 | st/synopsys/dcd_synopsys.c: Remove USBC PHY PLL stabilization delay for now | Uwe Bonnes | |
| While the ST code has a 2 ms stabilization delay for the USBC PHY PLL, running without this delay showed no problem for at leat 10 USB un/replug cycles. Observe for problems! | |||
| 2020-07-01 | only set turnaround in reset complete | hathach | |
| 2020-07-01 | correctly set turn around according to cpu clock | hathach | |
| help to run with low speed mcu | |||
| 2020-07-01 | added uart for h743 | hathach | |
| 2020-07-01 | Merge branch 'master' into add-stm-hs | hathach | |
| 2020-07-01 | clean up code | hathach | |
| 2020-07-01 | Merge pull request #452 from hathach/fix-dfu-rt | Ha Thach | |
| Fix dfu rt | |||
| 2020-07-01 | Update README.md | Ha Thach | |
| 2020-07-01 | Merge pull request #439 from UweBonnes/add-stm-hs | Ha Thach | |
| Add stm hs | |||
| 2020-07-01 | Merge pull request #453 from hathach/add-da14695-usb | Ha Thach | |
| Add da14695 usb | |||
| 2020-07-01 | added DA14695 DK USB bsp | hathach | |
| 2020-07-01 | rename file | hathach | |
| 2020-07-01 | fix dfu-rt to response to SET_INTERFACE and DFU_GETSTATUS | hathach | |
| fix #450 | |||
| 2020-07-01 | Merge pull request #451 from duempel/fix_synopsys_short_packet | Ha Thach | |
| Fix receiving of short packet data (Synopsys) | |||
| 2020-06-30 | correct led dfu_rt example | hathach | |
| also add example usage note | |||
| 2020-06-30 | Clear ep0_pending if rx short packet | Jan Dümpelmann | |
| 2020-06-30 | Fix receiving of short packet data (ep out) | Jan Dümpelmann | |
| 2020-06-30 | more clean up | hathach | |
| 2020-06-30 | revert rhport config in nxp mcus | hathach | |
| 2020-06-30 | stm32f723disco: USB HS enumerates. | Uwe Bonnes | |
| 2020-06-30 | cdc-acm: Use 512 bytes when in HS mode. | Uwe Bonnes | |
| Removes error: config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64 while enumerationg. | |||
| 2020-06-30 | dcd_synopsys: Handle HS and FS IP in one device | Uwe Bonnes | |
| FIXME: Allow run-time selection to allow to handle both HS and FS with one file F746 HS port enumerates with error config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64 | |||
| 2020-06-30 | Add Stm32F7xxdisco board support files | Uwe Bonnes | |
| Status with examples/device/cdc_msc: - make BOARD=stm32f723disco => OK - make BOARD=stm32f723disco PORT=1 => No Reaction - make BOARD=stm32f746disco => OK - make BOARD=stm32f746disco PORT=1 => Hangs during enumeration - make BOARD=stm32f769disco => Hangs during enumeration | |||
| 2020-06-30 | stm32h743nucleo: Enable Log via STLINK-VCP. | Uwe Bonnes | |
| 2020-06-30 | Merge branch 'master' into add-stm-hs | hathach | |
| 2020-06-30 | Merge pull request #427 from kasjer/kasjer/add-da1469x-support | Ha Thach | |
| Support for DA1469x MCU from Dialog Semiconductor | |||
 |
index : tinyusb.git | |
| Unnamed repository; edit this file 'description' to name the repository. |
| summaryrefslogtreecommitdiff |