| Age | Commit message (Collapse) | Author |
|---|
|
split-IN NAK storm (#3677)
Fix stm32f723disco host HIL: UART RX starvation + DWC2 split bulk NAK/XactErr handling (#3677)
stm32f7 BSP — UART RX starvation
- The host console USART shared interrupt priority with the USB OTG ISR, so a long
OTG interrupt could starve RXNE and drop received bytes. Raise the USART RX IRQ
above OTG_FS/OTG_HS in both the bare-metal and FreeRTOS init paths, guarded by
#ifdef UART_ID so boards without a UART console keep the default OTG priority.
dwc2 host — split NAK/XactErr handling
- Slave mode: a persistently-NAKing split bulk/control IN poll re-armed the
start-split immediately, storming the ISR and starving task context. Throttle by
disabling the channel and re-arming on the resulting halt (no frame deferral).
- Buffer-DMA mode: a pure split bulk-OUT NAK was unhandled, leaving the channel
halted and stalling the transfer — the dominant cause of CDC echo truncation.
Handle it by rewinding the buffer pointers and retrying the start-split
(Programming Guide v4.20a 5.1.4.2).
- Buffer-DMA mode: a split bulk-OUT XactErr was retried immediately, exhausting
HCD_XFER_ERROR_MAX before the transient cleared. Throttle via channel_disable +
re-arm to give the hub TT a recovery gap, mirroring slave mode.
- All three are scoped to split transfers (hcsplt.split_en); non-split NAK/XactErr
keep the core-handled / immediate-retry behavior. The OUT XactErr throttle also
excludes periodic split, where channel_disable() is a no-op and would wedge the
channel. The nak_disabled flag is generalized to retry_disabled and honors
xfer->closing so an endpoint close during a throttled retry tears down cleanly.
Verified on stm32f723disco HIL (slave + CFG_TUH_DWC2_DMA_ENABLE): host/cdc_msc_hid,
msc_file_explorer, and device_info all pass on both variants; DMA CDC echo went
from ~15-25% raw failure to 10/10 clean.
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
|
|
in irq
|
|
|
|
|
|
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
|
|
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
|
|
|
|
|
|
fix duplicated device attach for some devices which cause "USBH Defer Attach until current enumeration complete"
include dev0 for tuh_edpt_abort_xfer()
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
- BOARD_DEVICE/HOST_RHPORT_NUM to BOARD_TUD/H_RHPORT
- BOARD_DEVICE/HOST_RHPORT_SPEED to BOARD_TUD/H_MAX_SPEED
|
|
|
|
|
|
tested and work well
|
|
|
|
|
|
|
|
|
|
|
