| Age | Commit message (Collapse) | Author |
|---|
|
Class drivers: skip and account the SS endpoint companion descriptor in
every descriptor walk (hid, midi, midi2, ecm_rndis, printer, mtp, usbtmc),
via a shared usbd_skip_ss_ep_companion() helper in usbd_pvt.h (cdc/ncm
already handled; vendor/dfu naturally tolerant). usbtmc buffer grows to
1024 at SS to satisfy its packet-multiple assert. bth/audio/video are left
FS/HS-only (ISO-centric; ISO is unsupported on the CH569 dcd).
usbd.h: new SS template macros TUD_HID_SS_DESCRIPTOR(+INOUT),
TUD_MIDI_SS_DESCRIPTOR (+ DESC_EP_SS part), TUD_MIDI2_DESC_ALT1_EP_SS,
TUD_PRINTER_SS_DESCRIPTOR, TUD_MTP_SS_DESCRIPTOR,
TUD_USBTMC_BULK_SS_DESCRIPTORS/INT_SS_DESCRIPTOR, with _SS_DESC_LEN
counterparts (bulk endpoints hardcode 1024, companion after every EP).
Examples: 17 bulk/interrupt examples gain the full SS descriptor set
(EP0 512/64 clamp, SS device descriptor bcdUSB 3.20 mps0=2^9, SS config
with companions, BOS caps, speed-switched callbacks): cdc_dual_ports,
cdc_msc_freertos, dfu, dfu_runtime, dynamic_configuration,
hid_boot_interface, hid_composite(+freertos), hid_generic_inout,
hid_multiple_interface, midi_test(+freertos), midi2_device, msc_dual_lun,
mtp, printer_to_cdc, usbtmc, webusb_serial. msc_dual_lun is un-skipped for
CH569 using read-only flash disks (16KB RAM can't hold two 8KB RAM disks,
same as ch32v10x/v20x boards).
Validation: full example sweep green for hydrausb3_v1 (SPEED=super, 19
device ELFs) and raspberry_pi_pico; wTotalLength == sizeof() verified for
every SS configuration array in the built ELFs; ceedling 65/65;
pre-commit clean; code-size delta +0.0% on rp2040 (SS code folds out on
non-SS builds).
Co-Authored-By: Claude Fable 5 <[email protected]>
Claude-Session: https://claude.ai/code/session_019MRGjBT2NBkCoWwyDT4LaE
|
|
Groundwork for TinyUSB's first SuperSpeed port (WCH CH569):
- TUSB_SPEED_SUPER, OPT_MODE_SUPER_SPEED, TUD_OPT_SUPER_SPEED and
TUP_RHPORT_SUPERSPEED capability plumbing
- Allow CFG_TUD_ENDPOINT0_SIZE 512 on SS builds; EP0 control transfers
chunk at the runtime link speed (512 at SS, 64 on USB2 fallback)
- Handle SET_SEL, SET_ISOCH_DELAY and U1/U2_ENABLE feature requests
- Tolerate SS endpoint companion descriptors in usbd_open_edpt_pair,
cdcd_open and mscd_open interface parsing
- SS descriptor types/structs and template macros: endpoint companion,
BOS USB2-extension + SuperSpeed capability, SS config and
CDC/MSC/vendor SS variants (bulk fixed at 1024)
- cdc_msc example: SS device/config/BOS descriptors, speed-aware sizes
- Unit tests: SS endpoint validation, companion-tolerant endpoint pair
open, SET_SEL, SET_ISOCH_DELAY
All SS paths compile out when disabled: verified 0-byte code-size delta
on stm32f407disco (MinSizeRel) vs master; 65/65 unit tests pass.
Co-Authored-By: Claude Fable 5 <[email protected]>
|
|
* license: use SPDX identifiers for src/ headers
Replace the full ~20-line MIT license boilerplate on every src/ file with a
two-line SPDX tag (SPDX-FileCopyrightText + SPDX-License-Identifier), following
the REUSE convention used by CircuitPython and the Linux kernel. Removes ~3500
lines of duplicated boilerplate.
|
|
|
|
compile-time macros for simplicity and reduced complexity
|
|
|
|
for clarity and flexibility
|
|
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
|
|
|
|
|
|
|
|
CFG_TUD_VENDOR_RX_BUFSIZE = 0
update vendor device to omit ep buf when dedicated hwfifo is supported
|
|
|
|
|
|
|
|
|
|
|
|
|
|
cdc device omit ep buffer when hwfifo is supported
|
|
copilot/fix-dcd-edpt-xfer-issue
Signed-off-by: HiFiPhile <[email protected]>
|
|
Co-authored-by: Copilot <[email protected]>
|
|
|
|
tu_edpt_stream_open() does not clear fifo, allow for persistent stream when disconnect/reconnect
|
|
copilot/fix-dcd-edpt-xfer-issue
Signed-off-by: HiFiPhile <[email protected]>
|
|
|
|
copilot/fix-dcd-edpt-xfer-issue
Signed-off-by: HiFiPhile <[email protected]>
|
|
Signed-off-by: Mengsk <[email protected]>
|
|
- Added bool is_isr parameter to usbd_edpt_xfer() and usbd_edpt_xfer_fifo() wrapper functions
- These are called by class drivers to queue USB transfers
- Updated all callers to pass false by default (non-ISR context)
- Updated audiod_rx_xfer_isr() and audiod_tx_xfer_isr() to pass true (ISR context)
- All 21 unit tests pass
Co-authored-by: HiFiPhile <[email protected]>
|
|
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
add tud_cdc_n_notify_conn_speed_change()
add tud_cdc_notify_complete_cb()
|
|
|
|
add tx_overwritabe_if_not_connected for cdc driver configure
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
|
|
msc,cdc,hid
HIL enable device DMA for p4
|
|
Signed-off-by: HiFiPhile <[email protected]>
|
|
- usbd now change _usbd_dev.cfg_num before calling driver's open()
|
|
|
|
|
|
- new line, and code format
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
