| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2020-09-28 | synopsys: Fix fifo allocation schema | Jerzy Kasenberg | |
| Recommended FIFO allocation schema includes 2 maximum endpoint sizes. Comment suggested that this is the case while it would work according to this description only in checked endpoints were ascending sizes. Also two same size endpoints would be counted as one. That is fixed by way sz is filled. Calculation used too much modulo operation while single division was enough to account for odd FIFO sizes. Extra space that is evenly distributed between Bulk and control endpoints was incorrectly calculated it could prevent allocation of ISO endpoint FIFO when bulk endpoints existed with smaller endpoint numbers. Minimum endpoint FIFO size is 16 32bit words, FIFO space requirement is now observed. | |||
| 2020-09-06 | Start of sampling works. | Reinhard Panhuber | |
| 2020-09-04 | Merge remote-tracking branch 'upstream/master' into uac2 | Reinhard Panhuber | |
| 2020-08-20 | Fix formatting, get rid of all tabs. | Reinhard Panhuber | |
| 2020-08-19 | Commit before sharing. | Reinhard Panhuber | |
| Setup a test example - UNTESTED! Missing: Start transmitting audio data in set_interface. | |||
| 2020-08-16 | Merge remote-tracking branch 'upstream/master' into uac2 | Reinhard Panhuber | |
| Conflicts: src/device/usbd.c src/device/usbd.h src/portable/st/synopsys/dcd_synopsys.c | |||
| 2020-08-16 | Add EP close. Fix bug in set_interface within audio. | Reinhard Panhuber | |
| 2020-08-14 | Add dcd_edpt_close() to synopsys | Jerzy Kasenberg | |
| Endpoint close was implemented only in one driver so far. This function is needed for interfaces with several alternate settings. The way FIFO is allocated in dcd_edpt_open() allows to correctly close only one IN endpoint (the one that was opened last). | |||
| 2020-08-12 | Fix synopsys fifo flush during stall | Jerzy Kasenberg | |
| Wrong FIFO was flushed in dcd_edpt_stall(). (epnum - 1) should only be used when accessing DIEPTXF registers. For DIEPCTL and GRSTCTL epnum is correct index. | |||
| 2020-08-05 | Merge pull request #476 from kasjer/kasjer/fix-synopsys-fix-iso-frame-bit | Ha Thach | |
| Fix synopsys odd/even frame bit for IN ISO endpoints | |||
| 2020-08-04 | Fix synopsys odd/even frame bit for IN ISO endpoints | Jerzy Kasenberg | |
| For ISO endpoint driver has to specify when data is to be transmitted (odd or even frame). Currently code was not updating this bit resulting in data being sent every other frame. If interval was 1ms full data packed was sent every 2ms, and ZLP was sent in between. | |||
| 2020-08-03 | Implement dynamic FIFO RAM allocation according to configuration desc. | Reinhard Panhuber | |
| 2020-08-01 | enable pull-up in dcd_init() instead of usbd | hathach | |
| 2020-07-31 | Fix synopsys size check for ISO endpoint | Jerzy Kasenberg | |
| Constraint was incorrect for ISO endpoint as stated in TODO. | |||
| 2020-07-29 | fix nested extern declaration of 'SystemCoreClock' [-Werror=nested-externs] | hathach | |
| 2020-07-27 | Implement dynamic reallocation of RX and TX fifos for EP0. | Reinhard Panhuber | |
| Tested with EP0 size 8/16/32/64. | |||
| 2020-07-26 | add 'set_EP0_max_pkt_size(...)' and fix EP0 size to 64 bytes after reset | Reinhard Panhuber | |
| 2020-07-08 | change REDUCE_SPEED=0/1 to explicitly SPEED=high/full | hathach | |
| update readme, boards.md to add link to new stm boards | |||
| 2020-07-05 | Merge pull request #457 from UweBonnes/add-stm-hs | Ha Thach | |
| Add stm hs | |||
| 2020-07-03 | STM32/OTG_HS: Allow OTG_HS port to run at FS speed. | Uwe Bonnes | |
| Add "REDUCE_SPEED=1" to the compile options. | |||
| 2020-07-03 | update per review | hathach | |
| 2020-07-03 | fix NVIC disable typo | hathach | |
| 2020-07-02 | correct HSE_VALUE in hal_conf | hathach | |
| - although it is define in CFLAGS, it is worth to correct to be consistent with other build - extract set_speed() | |||
| 2020-07-02 | change default port some stm bsp | hathach | |
| - f769disco default port is highspeed port1 - remove PORT0 on stlink since the board only populated HS connector | |||
| 2020-07-02 | clean up | hathach | |
| 2020-07-01 | Merge branch 'add-stm-hs' of github.com:hathach/tinyusb into add-stm-hs | hathach | |
| 2020-07-01 | st/synopsys/dcd_synopsys.c: Remove USBC PHY PLL stabilization delay for now | Uwe Bonnes | |
| While the ST code has a 2 ms stabilization delay for the USBC PHY PLL, running without this delay showed no problem for at leat 10 USB un/replug cycles. Observe for problems! | |||
| 2020-07-01 | only set turnaround in reset complete | hathach | |
| 2020-07-01 | correctly set turn around according to cpu clock | hathach | |
| help to run with low speed mcu | |||
| 2020-07-01 | Merge branch 'master' into add-stm-hs | hathach | |
| 2020-07-01 | clean up code | hathach | |
| 2020-06-30 | Clear ep0_pending if rx short packet | Jan Dümpelmann | |
| 2020-06-30 | Fix receiving of short packet data (ep out) | Jan Dümpelmann | |
| 2020-06-30 | stm32f723disco: USB HS enumerates. | Uwe Bonnes | |
| 2020-06-30 | dcd_synopsys: Handle HS and FS IP in one device | Uwe Bonnes | |
| FIXME: Allow run-time selection to allow to handle both HS and FS with one file F746 HS port enumerates with error config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64 | |||
| 2020-06-30 | Merge branch 'master' into add-stm-hs | hathach | |
| 2020-06-29 | Merge pull request #399 from duempel/redesign_synopsys_receive | Ha Thach | |
| Improvements to Synopsys EP OUT | |||
| 2020-06-29 | Add author name to dcd_synopsys.c | Jan Dümpelmann | |
| 2020-06-26 | Remove EP0 remaining bytes manipulation | Jan Dümpelmann | |
| Renaming edpt_xact to edpt_schedule_packets | |||
| 2020-06-18 | Add transaction (edpt_xact) as sub transfer | Jan Dümpelmann | |
| A transfer can have one or multiple transactions. Usually only EP0 splits one xfer into multiple xact. | |||
| 2020-06-18 | Disable SOF in dcd_stm32_fsdev | Mengsk | |
| Signed-off-by: Mengsk <[email protected]> | |||
| 2020-06-17 | Fix IAR warnings. | Mengsk | |
| Pa039 : use of address of unaligned structure member. Pe188: enumerated type mixed with another type. | |||
| 2020-06-16 | fix stm32h743 priority with freeRTOS | hathach | |
| 2020-06-15 | Enhance EP FIFO allocation for both Fullspeed and Highspeed | hathach | |
| - Update shared RX FIFO calculation with FS/HS - IN FIFO EP - Interrupt -> use EPSize - Bulk/ISO -> use max(EPSize, remaining-fifo / non-opened-EPIN) | |||
| 2020-06-14 | cherry pick PR399 commit : Interrupt time improvements | Jan Dümpelmann | |
| 2020-06-14 | overwrite setup packet | hathach | |
| 2020-06-01 | allow hs ep open with 512 bytes | hathach | |
| 2020-05-31 | fixed EP0 size to 64 since LS is not supported in device mode | hathach | |
| - set turn-around and report actual speed in Enum Done - add dcd_event_bus_reset() helper to report speed | |||
| 2020-05-31 | able to detect as hs | hathach | |
| 2020-05-27 | try to get synopsys work with OTG HS + external PHY | hathach | |
