summaryrefslogtreecommitdiff
path: root/src/portable/st
AgeCommit message (Collapse)Author
2020-08-14Add dcd_edpt_close() to synopsysJerzy Kasenberg
Endpoint close was implemented only in one driver so far. This function is needed for interfaces with several alternate settings. The way FIFO is allocated in dcd_edpt_open() allows to correctly close only one IN endpoint (the one that was opened last).
2020-08-12Fix synopsys fifo flush during stallJerzy Kasenberg
Wrong FIFO was flushed in dcd_edpt_stall(). (epnum - 1) should only be used when accessing DIEPTXF registers. For DIEPCTL and GRSTCTL epnum is correct index.
2020-08-05Merge pull request #476 from kasjer/kasjer/fix-synopsys-fix-iso-frame-bitHa Thach
Fix synopsys odd/even frame bit for IN ISO endpoints
2020-08-04Fix synopsys odd/even frame bit for IN ISO endpointsJerzy Kasenberg
For ISO endpoint driver has to specify when data is to be transmitted (odd or even frame). Currently code was not updating this bit resulting in data being sent every other frame. If interval was 1ms full data packed was sent every 2ms, and ZLP was sent in between.
2020-08-01enable pull-up in dcd_init() instead of usbdhathach
2020-07-31Fix synopsys size check for ISO endpointJerzy Kasenberg
Constraint was incorrect for ISO endpoint as stated in TODO.
2020-07-29fix nested extern declaration of 'SystemCoreClock' [-Werror=nested-externs]hathach
2020-07-08change REDUCE_SPEED=0/1 to explicitly SPEED=high/fullhathach
update readme, boards.md to add link to new stm boards
2020-07-05Merge pull request #457 from UweBonnes/add-stm-hsHa Thach
Add stm hs
2020-07-03STM32/OTG_HS: Allow OTG_HS port to run at FS speed.Uwe Bonnes
Add "REDUCE_SPEED=1" to the compile options.
2020-07-03update per reviewhathach
2020-07-03fix NVIC disable typohathach
2020-07-02correct HSE_VALUE in hal_confhathach
- although it is define in CFLAGS, it is worth to correct to be consistent with other build - extract set_speed()
2020-07-02change default port some stm bsphathach
- f769disco default port is highspeed port1 - remove PORT0 on stlink since the board only populated HS connector
2020-07-02clean uphathach
2020-07-01Merge branch 'add-stm-hs' of github.com:hathach/tinyusb into add-stm-hshathach
2020-07-01st/synopsys/dcd_synopsys.c: Remove USBC PHY PLL stabilization delay for nowUwe Bonnes
While the ST code has a 2 ms stabilization delay for the USBC PHY PLL, running without this delay showed no problem for at leat 10 USB un/replug cycles. Observe for problems!
2020-07-01only set turnaround in reset completehathach
2020-07-01correctly set turn around according to cpu clockhathach
help to run with low speed mcu
2020-07-01Merge branch 'master' into add-stm-hshathach
2020-07-01clean up codehathach
2020-06-30Clear ep0_pending if rx short packetJan Dümpelmann
2020-06-30Fix receiving of short packet data (ep out)Jan Dümpelmann
2020-06-30stm32f723disco: USB HS enumerates.Uwe Bonnes
2020-06-30dcd_synopsys: Handle HS and FS IP in one deviceUwe Bonnes
FIXME: Allow run-time selection to allow to handle both HS and FS with one file F746 HS port enumerates with error config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64
2020-06-30Merge branch 'master' into add-stm-hshathach
2020-06-29Merge pull request #399 from duempel/redesign_synopsys_receiveHa Thach
Improvements to Synopsys EP OUT
2020-06-29Add author name to dcd_synopsys.cJan Dümpelmann
2020-06-26Remove EP0 remaining bytes manipulationJan Dümpelmann
Renaming edpt_xact to edpt_schedule_packets
2020-06-18Add transaction (edpt_xact) as sub transferJan Dümpelmann
A transfer can have one or multiple transactions. Usually only EP0 splits one xfer into multiple xact.
2020-06-18Disable SOF in dcd_stm32_fsdevMengsk
Signed-off-by: Mengsk <[email protected]>
2020-06-17Fix IAR warnings.Mengsk
Pa039 : use of address of unaligned structure member. Pe188: enumerated type mixed with another type.
2020-06-16fix stm32h743 priority with freeRTOShathach
2020-06-15Enhance EP FIFO allocation for both Fullspeed and Highspeedhathach
- Update shared RX FIFO calculation with FS/HS - IN FIFO EP - Interrupt -> use EPSize - Bulk/ISO -> use max(EPSize, remaining-fifo / non-opened-EPIN)
2020-06-14cherry pick PR399 commit : Interrupt time improvementsJan Dümpelmann
2020-06-14overwrite setup packethathach
2020-06-01allow hs ep open with 512 byteshathach
2020-05-31fixed EP0 size to 64 since LS is not supported in device modehathach
- set turn-around and report actual speed in Enum Done - add dcd_event_bus_reset() helper to report speed
2020-05-31able to detect as hshathach
2020-05-27try to get synopsys work with OTG HS + external PHYhathach
2020-05-26multiple port support for global otg basehathach
2020-05-26suporting multiple port (OTG FS + HS) for stm32hathach
2020-05-15Allow EP0 to use xfer sizes larger than one packetJan Dümpelmann
2020-05-15Interrupt time improvementsJan Dümpelmann
2020-05-08Synopsys OUT EP improvements:Jan Dümpelmann
- Use register based XFRSIZ to determine transfer complete (xfer->queued_len and xfer->short_packet were deleted) - Pop out as many RxFIFO data entries as available within a IRQ call - less application interruption due to XFRC calls
2020-05-04clean upJan Dümpelmann
renaming function and variables changing indent size
2020-04-29Changed switch into if statementsJan Dümpelmann
2020-04-29Redesign of Synopsys device transmissionJan Dümpelmann
Changes: - checking if tx buffer empty interrupt is masked - process more than one packet in isr - mask tx buffer empty just after all bytes were written - use of transmit_fifo_packet instead of transmit_packet
2020-04-27added comment for hw clearing TXFEhathach
2020-04-27TXFE is read only bithathach
generated by cgit v1.3.1 (git 2.54.0) at 2026-08-30 22:46:54 +0000