summaryrefslogtreecommitdiff
path: root/src
AgeCommit message (Collapse)Author
2020-07-16add fs & hs config for cdc_msc_freertos, midi_test, msc_dual_lunhathach
2020-07-16add tud_speed_get()hathach
- define both fs and hs configuration descriptor - rename CFG_TUD_CDC_EPSIZE to CFG_TUD_CDC_EP_BUFSIZE with default size of 64 for FS, and 512 for HS
2020-07-10Improve comment on CDC tud_cdc_write_available()Craig Hutchinson
Fixes #460
2020-07-10Merge pull request #456 from me-no-dev/esp32-s2-epin-toHa Thach
ESP32-S2: Detect EP IN Xfer Timeout
2020-07-08Merge pull request #447 from hathach/add-stm-hsHa Thach
Add support for STM32 OTG HS core
2020-07-08change REDUCE_SPEED=0/1 to explicitly SPEED=high/fullhathach
update readme, boards.md to add link to new stm boards
2020-07-05Merge pull request #457 from UweBonnes/add-stm-hsHa Thach
Add stm hs
2020-07-03STM32/OTG_HS: Allow OTG_HS port to run at FS speed.Uwe Bonnes
Add "REDUCE_SPEED=1" to the compile options.
2020-07-03update per reviewhathach
2020-07-03fix NVIC disable typohathach
2020-07-02ESP32-S2: Detect EP IN Xfer Timeoutme-no-dev
In some rare ocasions (bad cable, noise, etc.) data transfer might timeout and hang the endpoint, unless the interrupt flag is cleared. This pull request targets to solve that case.
2020-07-02correct HSE_VALUE in hal_confhathach
- although it is define in CFLAGS, it is worth to correct to be consistent with other build - extract set_speed()
2020-07-02change default port some stm bsphathach
- f769disco default port is highspeed port1 - remove PORT0 on stlink since the board only populated HS connector
2020-07-02clean uphathach
2020-07-01Merge branch 'add-stm-hs' of github.com:hathach/tinyusb into add-stm-hshathach
2020-07-01st/synopsys/dcd_synopsys.c: Remove USBC PHY PLL stabilization delay for nowUwe Bonnes
While the ST code has a 2 ms stabilization delay for the USBC PHY PLL, running without this delay showed no problem for at leat 10 USB un/replug cycles. Observe for problems!
2020-07-01only set turnaround in reset completehathach
2020-07-01correctly set turn around according to cpu clockhathach
help to run with low speed mcu
2020-07-01Merge branch 'master' into add-stm-hshathach
2020-07-01clean up codehathach
2020-07-01Merge pull request #452 from hathach/fix-dfu-rtHa Thach
Fix dfu rt
2020-07-01fix dfu-rt to response to SET_INTERFACE and DFU_GETSTATUShathach
fix #450
2020-06-30Clear ep0_pending if rx short packetJan Dümpelmann
2020-06-30Fix receiving of short packet data (ep out)Jan Dümpelmann
2020-06-30stm32f723disco: USB HS enumerates.Uwe Bonnes
2020-06-30dcd_synopsys: Handle HS and FS IP in one deviceUwe Bonnes
FIXME: Allow run-time selection to allow to handle both HS and FS with one file F746 HS port enumerates with error config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64
2020-06-30Merge branch 'master' into add-stm-hshathach
2020-06-30Merge pull request #427 from kasjer/kasjer/add-da1469x-supportHa Thach
Support for DA1469x MCU from Dialog Semiconductor
2020-06-29Merge pull request #399 from duempel/redesign_synopsys_receiveHa Thach
Improvements to Synopsys EP OUT
2020-06-29Add author name to dcd_synopsys.cJan Dümpelmann
2020-06-26Remove EP0 remaining bytes manipulationJan Dümpelmann
Renaming edpt_xact to edpt_schedule_packets
2020-06-25dcd_samd: Provide implementation for OPT_MCU_SAME5XJeff Epler
2020-06-24added OPT_MCU_SAME5X optionhathach
2020-06-18Add transaction (edpt_xact) as sub transferJan Dümpelmann
A transfer can have one or multiple transactions. Usually only EP0 splits one xfer into multiple xact.
2020-06-18Disable SOF in dcd_stm32_fsdevMengsk
Signed-off-by: Mengsk <[email protected]>
2020-06-17Fix IAR warnings.Mengsk
Pa039 : use of address of unaligned structure member. Pe188: enumerated type mixed with another type.
2020-06-16fix hs port1 build with net endpointhathach
2020-06-16fix stm32h743 priority with freeRTOShathach
2020-06-15Enhance EP FIFO allocation for both Fullspeed and Highspeedhathach
- Update shared RX FIFO calculation with FS/HS - IN FIFO EP - Interrupt -> use EPSize - Bulk/ISO -> use max(EPSize, remaining-fifo / non-opened-EPIN)
2020-06-14Fix wrong comment for IAD checks.Reinhard Panhuber
2020-06-14cherry pick PR399 commit : Interrupt time improvementsJan Dümpelmann
2020-06-14overwrite setup packethathach
2020-06-14improve usbd log for control transferhathach
2020-06-14revert CFG_TUSB_RHPORT0_MODE to previous wayhathach
2020-06-14Fix alignment.Reinhard Panhuber
2020-06-14Fix alignment.Reinhard Panhuber
2020-06-13Fix too strict checks on subclass and interface of iad descriptor.Reinhard Panhuber
2020-06-09Add DCD for Dialog DA1469x MCUJerzy Kasenberg
Dialog Semiconductor's BLE MCU DA1469x comes with full speed USB. It's base on National Semiconductor discrete USB controller USBN9603/4. This adds support for: - control/interrupt/bulk endpoints (up to 64 bytes) - ISO endpoint were not tested and may not work correctly - reset/sleep/wakeup are handled - code for VBUS changes is provided
2020-06-01adding speed detect on bus resethathach
2020-06-01allow hs ep open with 512 byteshathach
generated by cgit v1.3.1 (git 2.54.0) at 2026-08-31 15:01:54 +0000