Signed-off-by: Tom Rini <trini@konsulko.com>

Create a new configuration file: at91-sama5_common.h. Which includes the
configurations that reused by all SAMA5 chips.

at91-sama5_common.h includes:
- hw macros (clock, text_base and etc.)
- default commands.
- BOOTARGS
- U-Boot common configs.
NOTE: NOR flash definition should be put before including the common header.

For sama5d3-xplained:
- add CMD_SETEXPR

For sama5d3xek:
- add CMD_SETEXPR
- change CONFIG_SYS_MALLOC_LEN to (4*1024*1024)

Signed-off-by: Josh Wu <josh.wu@atmel.com>

Enable SPL support for at91sam9n12ek boards, now it supports
boot up from NAND flash, serial flash.

Signed-off-by: Bo Shen <voice.shen@atmel.com>

Enable SPL support for at91sam9x5ek board. Now, it supports
boot up from NAND flash and SPI flash.

Signed-off-by: Bo Shen <voice.shen@atmel.com>

Supports boot up from NAND flash with software ECC eanbled.
And supports boot up from SD/MMC card with FAT file system.

As the boot from SD/MMC card with FAT file system, the BSS
segment is too big to fit into SRAM, so, use the lds to put
it into SDRAM.

Signed-off-by: Bo Shen <voice.shen@atmel.com>

Config MCKR according to the datasheet sequence, or else it
will cause the MCKR configuration failed.

Remove timeout checking for clock configuration, if configure
the clock failed, let the system hang while not run in wrong
clock configuration.

Signed-off-by: Bo Shen <voice.shen@atmel.com>
Tested-by: Heiko Schocher <hs@denx.de>

Insteading in mmc's raw sectors, this patch will save the environment
in a fat file (uboot.env) in mmc card's first FAT patition by default.

If you want to save in mmc's raw sectors, you only need to define
CONFIG_ENV_IS_IN_MMC.

Signed-off-by: Josh Wu <josh.wu@atmel.com>
Acked-by: Bo Shen <voice.shen@atmel.com>

Add support for on-flash bad block table. This makes U-Boot handle an existing
BBT correctly.

Signed-off-by: David Dueck <davidcdueck@googlemail.com>
Reviewed-by: Boris BREZILLON <boris.brezillon@free-electrons.com>
CC: Boris BREZILLON <boris.brezillon@free-electrons.com>
CC: Josh Wu <josh.wu@atmel.com>
CC: Andreas Bießmann <andreas.devel@googlemail.com>
CC: Scott Wood <scottwood@freescale.com>
Acked-by: Josh Wu <josh.wu@atmel.com>

move MACH_TYPE into defconfig

Signed-off-by: Heiko Schocher <hs@denx.de>