Signed-off-by: Tom Rini <trini@konsulko.com>

- mpc8xxx spi driver fixes (Mario)
- mpc8xxx spi dm conversion (Mario, Jagan)
- SPI DM Migration update (Jagan)

- mxsfb DM_VIDEO conversion
- splash fix for DM_VIDEO configurations
- meson HDMI fix for boards without hdmi-supply regulator

First set of u-boot-atmel fixes for 2019.07 cycle

Now, we have few driver are fully converted into dm and few
are partially converted.

So, update the migration status accordingly.

Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>

Support DM in the MPC8xxx SPI driver, and remove the legacy SPI
interface.

Signed-off-by: Mario Six <mario.six@gdsys.cc>
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>

The comment before the transmission loop in conjunction with the
definition of SPI_TIMEOUT as 1000 implies that the loop is supposed to
have a timeout value of 1000 ms. But since there is no mdelay(1) or
similar in the loop body, the loop just runs 1000 times, without regard
for the time elapsed.

To correct this, use the standard get_timer functionality to properly
time out the loop after 1000 ms.

Signed-off-by: Mario Six <mario.six@gdsys.cc>
Acked-by: Jagan Teki <jagan@amarulasolutions.com>

Decreasing the bit length and increasing the write data pointer should
be done when there are more than 32 bit of data, not 16 bit.

This did not produce incorrect behavior, because the only time where the
two checks produce different outcomes is the case of 16 < bitlen < 32,
and in this case the subsequent transmission is the last one regardless,
hence the additional bit length decrease and write data pointer increase
has no effect anyway.

Still, the correct check is the check for "bitlen > 32", so correct this
behavior.

Signed-off-by: Mario Six <mario.six@gdsys.cc>
Acked-by: Jagan Teki <jagan@amarulasolutions.com>

Minize the time the adapter is disabled (via SPI_MODE_EN
clearing/setting) to just the character length setting, and only set up
the temporary data writing variable right before we need it, so there is
a more clear distinction between setting up the SPI adapter, and setting
up the data to be written.

Signed-off-by: Mario Six <mario.six@gdsys.cc>
Acked-by: Jagan Teki <jagan@amarulasolutions.com>

Instead of having a table right before the code implementing the length
setting for documentation, have inline comments for the if branches
actually implementing the length setting described table's entries
(which is readable thanks to the set_char_len function).

Signed-off-by: Mario Six <mario.six@gdsys.cc>
Acked-by: Jagan Teki <jagan@amarulasolutions.com>