u-boot.git/README, branch v2019.04-rc2

i2c: Remove ancient zynq_i2c driver

2019-02-14T13:31:10Z

This driver is replaced by drivers/i2c/i2c-cdns.c DM based driver. Signed-off-by: Michal Simek Acked-by: Heiko Schocher

Kconfig: Migrate CONFIG_BUILD_TARGET

2019-02-02T13:23:57Z

Migrate CONFIG_BUILD_TARGET into Kconfig. Signed-off-by: Jagan Teki

configs: Migrate CONFIG_DFU_MMC again

2019-01-25T17:04:16Z

A few platforms recently added in CONFIG_DFU_MMC under include/configs rather than via the defconfig, update them. Signed-off-by: Tom Rini

net: remove CONFIG_MCAST_TFTP

2019-01-24T17:35:30Z

No mainline board enables CONFIG_MCAST_TFTP and there have been compilation issues with the code for some time. Additionally, it has a potential buffer underrun issue (reported as a side note in CVE-2018-18439). Remove the multicast TFTP code but keep the driver API for the future addition of IPv6. Cc: Simon Goldschmidt Signed-off-by: Chris Packham Acked-by: Joe Hershberger

spi: Zap CONFIG_HARD_SPI

2018-11-27T15:36:53Z

In legacy CONFIG_HARD_SPI initalizing spi_init code, which was removed during dm conversion cleanup. So remove the dead instances of CONFIG_HARD_SPI, and related code. Signed-off-by: Jagan Teki

Merge branch 'master' of git://git.denx.de/u-boot-spi

2018-10-02T21:01:46Z

This is the PR for SPI-NAND changes along with few spi changes. [trini: Re-sync changes for ls1012afrwy_qspi*_defconfig] Signed-off-by: Tom Rini

MIPS: cache: remove config option CONFIG_SYS_MIPS_CACHE_MODE

2018-09-22T19:04:10Z

Caches should be configured to mode CONF_CM_CACHABLE_NONCOHERENT (or CONF_CM_CACHABLE_COW when a CM is available). There is no need to make this configurable. Signed-off-by: Daniel Schwierzeck

MIPS: start.S: make boot config at offset 0x10 configurable

2018-09-22T18:59:22Z

Some MIPS systems store some board-specific boot configuration in the U-Boot binary at offset 0x10. This is used by Malta boards and by Lantiq/Intel SoC's when booting from parallel NOR flash. Convert the hard-coded values to Kconfig options to remove such board-specific stuff out of the generic start.S code. This also deprecates the config option CONFIG_SYS_XWAY_EBU_BOOTCFG. Signed-off-by: Daniel Schwierzeck

mtd: move NAND files into a raw/ subdirectory

2018-09-20T14:40:49Z

NAND flavors, like serial and parallel, have a lot in common and would benefit to share code. Let's move raw (parallel) NAND specific code in a raw/ subdirectory, to ease the addition of a core file in nand/ and the introduction of a spi/ subdirectory specific to SPI NANDs. Signed-off-by: Miquel Raynal

Remove CONFIG_USE_STDINT

2018-09-11T00:48:16Z

You do not need to use the typedefs provided by compiler. Our compilers are either IPL32 or LP64. Hence, U-Boot can/should always use int-ll64.h typedefs like Linux kernel, whatever the typedefs the compiler internally uses. Signed-off-by: Masahiro Yamada