u-boot.git/arch/arm/dts/Makefile, branch v2016.09

sunxi: Add defconfig and dts file for the Orange Pi Plus2E SBC

2016-09-03T11:05:43Z

The Orange Pi Plus2E is an extended version of the Orange Pi Pc Plus, with 2G RAM and an external gbit ethernet phy. The dts file is identical to the one submitted to the upstream kernel, except that it has the pending patch to enable the ethernet controller squashed in, as u-boot already has sun8i-emac support. Signed-off-by: Hans de Goede

sunxi: Add support for A33-OLinuXino board

2016-09-03T08:33:44Z

A33-OLinuXino is A33 development board designed by Olimex LTD. It has AXP223 PMU, 1GB DRAM, a micro SD card, one USB-OTG connector, headphone and mic jacks, connector for LiPo battery and optional 4GB NAND Flash. It has two 40-pin headers. One for LCD panel, and one for additional modules. Also there is CSI/DSI connector. The dts files are identical to the ones submitted to the upstream kernel. Signed-off-by: Stefan Mavrodiev Reviewed-by: Hans de Goede Signed-off-by: Hans de Goede

sunxi: add proper device tree for iNet D978 rev2 boards

2016-09-03T08:04:15Z

Add a proper dts for the iNet D978 rev2 based A33 tablets. Signed-off-by: Icenowy Zheng Acked-by: Hans de Goede Signed-off-by: Hans de Goede

ARM: tegra: Add support for TK1-SOM board from Colorado Engineering

2016-09-01T16:24:30Z

The Colorado TK1 SOM is a small form factor board similar to the Jetson TK1. The main differences lie in the pinmux, and in that the PCIe controller is set to use in 4lanes+1lane, rather than 2+2. The pinmux header here was generated from a spreadsheet provided by Colorado Engineering using the tegra-pinmux scripts. The spreadsheet was converted from v09 to v11 by me. Signed-off-by: Peter Chubb Acked-by: Stephen Warren Signed-off-by: Tom Warren

ARM: tegra: use numeric versioning for p2771-0000

2016-08-30T18:14:53Z

The board ID EEPROM and board ID stickers on p2771-0000 will use a numeric versioning scheme, with version numbers such as 000/100/200/300/400/500. Within NVIDIA, these versions are also known as A00/A01/A02/A03/A04/B00. However, that numbering scheme is not easily visible outside of NVIDIA, and so does not make much sense to use. Convert U-Boot to use the readily visible numeric scheme. Also, it turns out that the current A02 DT actually applies to board versions 000/100/200 (A00..A02). Consequently rename this to 000 not 200 so that all U-Boot builds are named after the first version of the HW they support. Signed-off-by: Stephen Warren Signed-off-by: Tom Warren

sun5i: Add defconfig and dts file for the Empire Electronix M712 tablet

2016-08-26T14:58:36Z

Add a defconfig and dts file for the Empire Electronix M712 tablet, this is a 7" A13 tablet, with micro-usb (otg), headphone and micro-sd slots on the outside. It uses a Goodix gt811 touchscreen controller, a RTL8188CTV wifi chip and a DMART06 (1238a4) accelerometer. The dts file is identical to the one submitted to the upstream kernel. Signed-off-by: Hans de Goede

sunxi: Sync dts files with upstream kernel

2016-08-26T14:58:36Z

Sync dts files with the current (Aug 18th 2016) state of Maxime's linux/sunxi/for-next repo. Note this commit also updates configs/MSI_Primo81_defconfig, adding: "# CONFIG_REQUIRE_SERIAL_CONSOLE is not set", this is necessary because the tablet does not have a reachable uart so the dts sync drops its serial0 alias. Signed-off-by: Hans de Goede Acked-by: Ian Campbell

sun6i: Add defconfig and dts file for tablets using the inet-q972 PCB

2016-08-26T14:58:36Z

Add a defconfig and dts file for tablets using the generic inet-q972 PCB. Tablets with this PCB feature a mini-hdmi output, micro-usb usb-host, micro-usb usb-otg, 3.5mm headphone jack, a micro sd slot, (mini) power-barrel and an usb wifi module. This has been tested on a 9.7" 1024x768 qware qw tb9718-qhd tablet. The dts files are identical to the ones submitted to the upstream kernel. Signed-off-by: Hans de Goede Acked-by: Ian Campbell

ARM: at91/dt: Add device tree for SAMA5D2 Xplained

2016-08-15T20:58:04Z

Add device tree for SAMA5D2 Xplained board. Signed-off-by: Wenyou Yang

rockchip: add support for rk3288 miniarm board

2016-08-05T23:56:08Z

Miniarm is a rockchip rk3288 based development board, which has lots of interface such as HDMI, USB, micro-SD card, Audio etc. Signed-off-by: Ziyuan Xu Acked-by: Simon Glass