u-boot.git/arch/arm/lib/Makefile, branch u-boot-2013.01.y

arm: Make interrupts.o and reset.o in libarm also appear in SPL

2013-01-10T21:22:15+00:00

SPL u-boot may call do_reset() which depends on interrupts.o and reset.o.
So make them also appear in SPL.

Signed-off-by: Tom Wai-Hong Tam 
Signed-off-by: Simon Glass

arm: move C runtime setup code in crt0.S

2013-01-08T21:14:50+00:00

Move all the C runtime setup code from every start.S
in arch/arm into arch/arm/lib/crt0.S. This covers
the code sequence from setting up the initial stack
to calling into board_init_r().

Also, rewrite the C runtime setup and make functions
board_init_*() and relocate_code() behave according to
normal C semantics (no jumping across the C stack any
more, etc).

Some SPL targets had to be touched because they use
start.S explicitly or for some reason; the relevant
maintainers and custodians are cc:ed.

Signed-off-by: Albert ARIBAUD

SPL: Create arch/arm/lib/spl.c for board_init_f and jump_to_image_linux

2012-09-27T16:49:59+00:00

In SPL (CONFIG_SPL_FRAMEWORK) board_init_f must setup the stack pointer,
clear the BSS and call board_init_r.  We mark this as weak as some
platforms may need to perform additional initalization at this point.
We provide a gd that we know will be in a usable location, once the BSS
has been cleared to help with this as well.  Finally, we no longer call
relocate_code so remove that from the armv7 version.

Next, both board_init_f and jump_to_image_linux are going to be
inherently arch-specific, so move these versions to arch/arm/lib/spl.c

Signed-off-by: Tom Rini

arm: enable libgcc build for SPL

2012-09-01T12:58:22+00:00

Enable the building of private libgcc for SPL

Signed-off-by: Allen Martin 
Acked-by: Stephen Warren 
Tested-by: Thierry Reding 
Signed-off-by: Tom Warren

Add cache functions to SPL for armv7

2012-03-27T20:05:29+00:00

Signed-off-by: Stefano Babic 
CC: Tom Rini 
CC: Wolfgang Denk 
CC: Simon Schwarz

scaled down version of generic libraries for SPL

2011-07-26T12:44:25+00:00

Signed-off-by: Aneesh V

armv7: add PL310 support to u-boot

2011-07-04T08:55:25+00:00

PL310 is the L2$ controller from ARM used in many SoCs
including the Cortex-A9 based OMAP4430

Add support for some of the key PL310 operations
	- Invalidate all
	- Invalidate range
	- Flush(clean & invalidate) all
	- Flush range

Signed-off-by: Aneesh V

armv7: rename cache related CONFIG flags

2011-07-04T08:55:25+00:00

Replace the cache related CONFIG flags with more meaningful
names. Following are the changes:

CONFIG_L2_OFF	     -> CONFIG_SYS_L2CACHE_OFF
CONFIG_SYS_NO_ICACHE -> CONFIG_SYS_ICACHE_OFF
CONFIG_SYS_NO_DCACHE -> CONFIG_SYS_DCACHE_OFF

Signed-off-by: Aneesh V 
V2:
 * Changed CONFIG_L2_OFF -> CONFIG_SYS_NO_L2CACHE
V4:
 * Changed all three flags to the final names suggested as above
   and accordingly changed the commit message

arm: Use optimized memcpy and memset from linux

2011-04-27T17:38:07+00:00

Using optimized versions of memset and memcpy from linux brings a quite
noticeable speed (x2 or better) improvement for these two functions.

Here are some numbers for test done with jadecpu

                           | HEAD(1)| HEAD(1)| HEAD(2)| HEAD(2)|
                           |        | +patch |        | +patch |
---------------------------+--------+--------+--------+--------+
Reset to prompt            |  438ms |  330ms |  228ms |  120ms |
                           |        |        |        |        |
TFTP a 3MB img             | 4782ms | 3428ms | 3245ms | 2820ms |
                           |        |        |        |        |
FATLOAD USB a 3MB img*     | 8515ms | 8510ms | ------ | ------ |
                           |        |        |        |        |
BOOTM LZO img in RAM       | 3473ms | 3168ms |  592ms |  592ms |
 where CRC is              |  615ms |  615ms |   54ms |   54ms |
 uncompress                | 2460ms | 2462ms |  450ms |  451ms |
 final boot_elf            |  376ms |   68ms |   65ms |   65ms |
                           |        |        |        |        |
BOOTM LZO img in FLASH     | 3207ms | 2902ms | 1050ms | 1050ms |
 where CRC is              |  600ms |  600ms |  135ms |  135ms |
 uncompress                | 2209ms | 2211ms |  828ms |  828ms |
                           |        |        |        |        |
Copy 1.4MB from NOR to RAM |  134ms |   72ms |  120ms |   70ms |

(1) No dcache
(2) dcache enabled in board_init
*Does not work when dcache is on

Size impact:

C version:
   text    data     bss     dec     hex filename
 202862   18912  266456  488230   77326 u-boot

ASM version:
   text    data     bss     dec     hex filename
 203798   18912  266288  488998   77626 u-boot
222712  u-boot.bin

Signed-off-by: Matthias Weisser

Switch from archive libraries to partial linking

2010-11-17T20:02:18+00:00

Before this commit, weak symbols were not overridden by non-weak symbols
found in archive libraries when linking with recent versions of
binutils.  As stated in the System V ABI, "the link editor does not
extract archive members to resolve undefined weak symbols".

This commit changes all Makefiles to use partial linking (ld -r) instead
of creating library archives, which forces all symbols to participate in
linking, allowing non-weak symbols to override weak symbols as intended.
This approach is also used by Linux, from which the gmake function
cmd_link_o_target (defined in config.mk and used in all Makefiles) is
inspired.

The name of each former library archive is preserved except for
extensions which change from ".a" to ".o".  This commit updates
references accordingly where needed, in particular in some linker
scripts.

This commit reveals board configurations that exclude some features but
include source files that depend these disabled features in the build,
resulting in undefined symbols.  Known such cases include:
- disabling CMD_NET but not CMD_NFS;
- enabling CONFIG_OF_LIBFDT but not CONFIG_QE.

Signed-off-by: Sebastien Carlier