u-boot.git/arch/arm, branch v2014.07

Merge branch 'master' of git://www.denx.de/git/u-boot-imx

2014-07-11T18:54:48Z

i.MX6DL/S: add drive-strength back to pads DISP0_DAT2/DAT10

2014-07-10T13:23:56Z

The pad settings for DISP0_DATA02 and DISP0_DAT10 were not set in the same way as DISP0_DAT00-23, causing much flicker in parallel RGB displays on Dual-Lite and Solo processors. These settings now match the i.MX6 Dual and Quad core versions. Note that this fixes a regression in commit b47abc3 and that this is the second time we've had a regression on these two pads (See commit e654ddf). Signed-off-by: Eric Nelson Acked-by: Otavio Salvador

usb: phy: omap_usb_phy: implement usb_phy_power() for AM437x

2014-07-09T20:11:51Z

Newer AM437x silicon requires us to explicitly power up the USB2 PHY. By implementing usb_phy_power() we can achieve that. Signed-off-by: Felipe Balbi

Merge branch 'master' of git://www.denx.de/git/u-boot-imx

2014-07-09T13:21:51Z

mx6: soc: Update the comments of set_ldo_voltage()

2014-07-09T13:10:10Z

Commit 3d622b78 (mx6: soc: Introduce set_ldo_voltage()) introduces set_ldo_voltage() function that can be used to set the voltages of any of the three LDO regulators controlled by the PMU_REG_CORE register. Prior to this commit there was a single set_vddsoc() which only configured the VDDSOC regulator. Update the comments to align with the new set_ldo_voltage() implementation. Signed-off-by: Fabio Estevam

MX6: Correct calculation of PLL_SYS

2014-07-09T12:55:30Z

DIV_SELECT is used as Fout = Fin * div_select / 2.0, so we should do the shift after the multiply to avoid rounding errors Signed-off-by: Andre Renaud

kmake: include DTB section into u-boot.bin if CONFIG_OF_EMBED enabled

2014-07-07T23:47:24Z

Fixes a bug when objcopy doesn't put .dtb.init.rodata section to resulting u-boot.bin, so u-boot was unable to find embedded DTB.

am43xx: Tune the system to avoid DSS underflows

2014-07-07T23:42:34Z

* This is done by limiting the ARM's bandwidth and setting DSS priority in the EMIF controller to ensure underflows do not occur.

am43xx: Update EMIF DDR3 Configuration for AM43x GP

2014-07-07T23:42:34Z

* Boot failures have been discovered due to a combination of routing issues and non optimal ddr3 timings in the EMIF * Since ddr3 timings are different after significant board layout changes different timings are required for alpha, beta and production boards. Signed-off-by: Franklin S. Cooper Jr

ARM: emif4: wait for CM_DLL_READYST to be set

2014-07-07T23:42:33Z

The code intends for the CM_DLL_READYST to be set, but actually polls till any bit is set since the logical AND is used instead of the bitwise one is used. Fix it. cc: Lokesh Vutla Signed-off-by: Jeroen Hofstee