u-boot.git/arch/nios2, branch v2016.01-rc2

nios2: 10m50: change to ns16550 uart

2015-11-22T02:50:18Z

Change to ns16550 uart for 10m50 devboard based on a new Altera release. Signed-off-by: Thomas Chou Reviewed-by: Tom Rini Acked-by: Simon Glass

nios2: zap ioremap

2015-11-18T13:18:30Z

Zap ioremap(), as it is replaced by map_physmem(,,MAP_NOCACHE). Signed-off-by: Thomas Chou Reviewed-by: Marek Vasut

nios2: dma-mapping.h: change ioremap to map_physmem

2015-11-18T13:18:30Z

Change ioremap() to map_physmem(), as it is more used in u-boot. Signed-off-by: Thomas Chou Reviewed-by: Marek Vasut

nios2: add 10m50 devboard support

2015-11-12T00:26:59Z

Add 10m50 devboard support. It is based on the Golden Hardware Reference Design (GHRD), available at, http://rocketboards.org/foswiki/view/Documentation/ AlteraMAX1010M50RevCDevelopmentKitLinuxSetup Though we supported only one nios2-generic board in the past. Now, with the removal of the nios2-generic board dir, adding new nios2 boards to u-boot is easier than before. It should be helpful to add those boards supported in Linux mainline. There are only two such nios2 boards, the 3c120 devboard and 10m50 devboard. The nios2-generic is actually 3c120, and should restore the name. The 10m50 is this one. Signed-off-by: Thomas Chou Reviewed-by: Marek Vasut

nios2: add memcpy_fromio and memcpy_toio

2015-11-12T00:26:58Z

Add memcpy_fromio() and memcpy_toio(). Signed-off-by: Thomas Chou

Various Makefiles: Add SPDX-License-Identifier tags

2015-11-10T14:19:52Z

After consulting with some of the SPDX team, the conclusion is that Makefiles are worth adding SPDX-License-Identifier tags too, and most of ours have one. This adds tags to ones that lack them and converts a few that had full (or in one case, very partial) license blobs into the equivalent tag. Cc: Kate Stewart Signed-off-by: Tom Rini

Merge branch 'master' of git://git.denx.de/u-boot-nios

2015-11-06T14:21:33Z

nios2: fix cached mode in clearing the BSS

2015-11-06T01:14:12Z

As the generic board runs in cached mode, it should not use "stwio" which bypass the cache. Signed-off-by: Thomas Chou Reviewed-by: Chin Liang See

nios2: remove CONFIG_SYS_INIT_SP macro

2015-11-06T01:14:12Z

Remove CONFIG_SYS_INIT_SP macro, as the initial stack is set to below the u-boot code. Signed-off-by: Thomas Chou Reviewed-by: Marek Vasut Reviewed-by: Chin Liang See

nios2: change virt_to_phys to use physaddr_mask in global data

2015-11-06T01:14:11Z

As virt_to_phys() is used a lot in DMA transfer, change it to use physaddr_mask in global data. This will save an "if" statement and get a little faster. Signed-off-by: Thomas Chou Acked-by: Marek Vasut