u-boot.git/arch, branch v2013.10-rc2

usb: ehci-mx5: Use 'bool' instead of 'unsigned char'

2013-08-26T19:56:34Z

The 'enable' argument can be better expressed as boolean. Signed-off-by: Fabio Estevam Reviewed-by: Otavio Salvador

ARM: OMAP5: USB: Add OMAP5 common USB EHCI information

2013-08-26T19:55:46Z

* Enable the OMAP5 EHCI host clocks * Add OMAP5 EHCI register definitions * Add OMAP5 ES2 host revision Signed-off-by: Dan Murphy

Merge branch 'master' of git://git.denx.de/u-boot-mpc85xx

2013-08-21T20:27:47Z

Fix for incorrect conversion hex string to number (FMAN firmware address).

2013-08-20T18:51:26Z

Signed-off-by: Николай Пузанов Acked-by: York Sun

powerpc/sec: Add workaround for SEC A-003571

2013-08-20T17:47:07Z

Multiple read/write transactions initiated by security engine may cause system to hang. Workaround: set MCFGR[AXIPIPE] to 0 to avoid hang. Signed-off-by: Shengzhou Liu Acked-by: York Sun

powerpc/t4240: add QSGMII interface support

2013-08-20T17:46:48Z

Also some fix for QSGMII. 1. fix QSGMII configure of Serdes2. 2. fix PHY address of QSGMII MAC9 & MAC10 for each FMAN. 3. fix dtb for QSGMII interface. Signed-off-by: Shaohui Xie Acked-by: York Sun

powerpcv2: Print hardcoded size like print_size() does

2013-08-20T17:38:12Z

Makes the startup output more consistent Signed-off-by: Shruti Kanetkar Acked-by: Andy Fleming Acked-by: Stefan Roese Acked-by: York Sun

powerpc: Use print_size() where appropriate

2013-08-20T17:37:58Z

Makes the startup output more consistent Signed-off-by: Shruti Kanetkar Acked-by: Andy Fleming Acked-by: York Sun

powerpc: Fix CamelCase checkpatch warnings

2013-08-20T16:57:51Z

85xx, 86xx PowerPC folders have code variables with CamelCase naming conventions. because of this code checkpatch script generates "WARNING: Avoid CamelCase". Convert variables name to normal naming convention and modify board, driver files with updated the new structure. Signed-off-by: Prabhakar Kushwaha Acked-by: York Sun

powerpc: mpc85xx: Support booting from SD Card with SPL

2013-08-20T16:47:26Z

The code from the internal on-chip ROM. It loads the final uboot image into DDR, then jump to it to begin execution. The SPL's size is sizeable, the maximum size must not exceed the size of L2 SRAM. It initializes the DDR through SPD code, and copys final uboot image to DDR. So there are two stage uboot images: * spl_boot, 96KB size. The env variables are copied to L2 SRAM, so that ddr spd code can get the interleaving mode setting in env. It loads final uboot image from offset 96KB. * final uboot image, size is variable depends on the functions enabled. Signed-off-by: Ying Zhang Acked-by: York Sun