u-boot.git/arch, branch v2016.03-rc2

arm: build some file(s) as ARM mode only

2016-02-15T17:04:46+00:00

Signed-off-by: David Müller

arm: the ARM920T is THUMB capable, so select the appropriate ISA

2016-02-15T17:04:45+00:00

Signed-off-by: David Müller

arm: make sure board_init_r() is being called using the right mode (ARM / THUMB)

2016-02-15T17:04:45+00:00

Signed-off-by: David Müller

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

2016-02-14T13:39:32+00:00

ARM: uniphier: add support for PH1-Pro4 Ace and Sanji boards

2016-02-14T08:07:46+00:00

Initial commit for PH1-Pro4 Ace and Sanji boards.

Note:
There are two variants for the Ace board in terms of the amount of
DDR memory; 1GB or 2GB.

Signed-off-by: Masahiro Yamada

ARM: dts: uniphier: enable I2C channel 2 of ProXstream2 Gentil board

2016-02-14T08:07:46+00:00

This is used for on-board inter-connection.

Signed-off-by: Masahiro Yamada

ARM: dts: uniphier: add EEPROM node for ProXstream2 Gentil board

2016-02-14T08:07:46+00:00

This board has an EEPROM connected to the I2C channel 0 of the SoC.
Its slave address is 0x54.

Signed-off-by: Masahiro Yamada

ARM: uniphier: adjust DDR clock delay line for ProXstream2

2016-02-14T08:07:46+00:00

It turned out that DDR channel 2 was not working on ProXstream2
Vodka board.  Add the missing ACBLDR0 register setting to adjust
the delay between the clock lines and the address/command lines.

Signed-off-by: Masahiro Yamada

ARM: uniphier: move cmd_ddrmphy.c to fix build error

2016-02-14T08:07:46+00:00

If CONFIG_CMD_DDRMPHY_DUMP is enabled, the build fails.

Fixes: 93d92d46cd01 ("ARM: uniphier: add dump command for DDR Multi PHY registers")
Signed-off-by: Masahiro Yamada

ARM: uniphier: fix makefiles to build cmd_ddr(m)phy.c

2016-02-14T08:07:46+00:00

The U-Boot proper building needs to descend arch/arm/mach-uniphier/dram
to build these commands.

Fixes: 93d92d46cd01 ("ARM: uniphier: add dump command for DDR Multi PHY registers")
Signed-off-by: Masahiro Yamada