u-boot.git/board/amcc, branch v1.3.2

fix taihu soft spi_read

2008-03-07T08:15:26Z

The taihu board used gpio_read_out_bit which reads the output register and not the pin state. Signed-off-by: Markus Brunner

ppc4xx: Fix acadia_nand build problem

2008-02-25T15:50:48Z

Don't include testdram() on NAND-booting target acadia_nand. This saves a few bytes and makes the target build clean again. Signed-off-by: Stefan Roese

PPC440EPx: Optionally enable second I2C bus

2008-02-16T06:00:03Z

The option CONFIG_I2C_MULTI_BUS does not have any effect on Sequoia, the PPC440EPx reference platform, because IIC1 is never enabled. Add Sequoia board code to turn on IIC1 if CONFIG_I2C_MULTI_BUS is selected. Signed-off-by: Mike Nuss Cc: Stefan Roese

Coding Style Cleanup; update CHANGELOG

2008-01-23T13:31:17Z

Signed-off-by: Wolfgang Denk

ppc4xx: Fix remaining CONFIG_COMMANDS in 4xx files

2008-01-17T06:50:17Z

Signed-off-by: Stefan Roese

ppc4xx: Sequoia coding style cleanup and beautification

2008-01-16T10:24:28Z

Signed-off-by: Matthias Fuchs

ppc4xx: Update Kilauea CPLD configuration with USB PHY reset bit

2008-01-14T09:05:05Z

Now that bit 29 is the USB PHY reset bit, update the Kilauea port to remove the USB PHY reset after powerup. The CPLD will keep the USB PHY in reset (active low) until the bit is set to 1 in board_early_init_f(). Signed-off-by: Stefan Roese

Makalu: fix compile warning

2008-01-13T15:07:44Z

Signed-off-by: Wolfgang Denk

Fix linker scripts: add NOLOAD atribute to .bss/.sbss sections

2008-01-12T19:31:39Z

With recent toolchain versions, some boards would not build because or errors like this one (here for ocotea board when building with ELDK 4.2 beta): ppc_4xx-ld: section .bootpg [fffff000 -> fffff23b] overlaps section .bss [fffee900 -> fffff8ab] For many boards, the .bss section is big enough that it wraps around at the end of the address space (0xFFFFFFFF), so the problem will not be visible unless you use a 64 bit tool chain for development. On some boards however, changes to the code size (due to different optimizations) we bail out with section overlaps like above. The fix is to add the NOLOAD attribute to the .bss and .sbss sections, telling the linker that .bss does not consume any space in the image. Signed-off-by: Wolfgang Denk

ppc4xx: Fix sdram init on Sequoia boards

2008-01-11T14:53:58Z

Clear possible errors in MCSR resulting from data-eye-search. If not done, then we could get an interrupt later on when exceptions are enabled. Signed-off-by: Stefan Roese