u-boot.git/board/freescale/mx23evk/spl_boot.c, branch v2016.01

ARM: mxs: Receive r0 and r1 passed from BootROM

2013-09-10T17:12:54Z

Make sure value in register r0 and r1 is preserved and passed to the board_init_ll() and mxs_common_spl_init() where it can be processed further. The value in r0 can be configured during the BootStream generation to arbitary value, r1 contains pointer to return value from CALL'd function. This patch also clears the value in r0 before returning to BootROM to make sure the BootROM is not confused by this value. Finally, this patch cleans up some comments in the start.S file. Signed-off-by: Marek Vasut Cc: Fabio Estevam Cc: Stefano Babic

Add GPL-2.0+ SPDX-License-Identifier to source files

2013-07-24T13:44:38Z

Signed-off-by: Wolfgang Denk [trini: Fixup common/cmd_io.c] Signed-off-by: Tom Rini

mx23evk: Add splash screen support

2013-05-16T15:44:46Z

Enable display support. Signed-off-by: Fabio Estevam

mx23evk: Do not set voltage selection bit for SSP pads

2013-05-06T07:55:51Z

mx23 SSP pad registers do not contain voltage selection bit, so just remove it. Signed-off-by: Fabio Estevam

mx23evk: Fix DDR pin iomux settings

2013-05-05T15:08:46Z

Change MUX_CONFIG_EMI to use the same drive strength as the bootlets code from Freescale, which results in much better stability. Signed-off-by: Fabio Estevam

mx23evk: Adjust DRAM control register to use full 128MB of RAM

2013-03-07T16:22:57Z

Adjust HW_DRAM_CTL14 to enable the chip selects to allow usage of full 128MB of RAM. Signed-off-by: Otavio Salvador

mx23evk: Add initial board support

2013-01-28T10:51:04Z

The following features are supported: * 128 MB DDR1 SDRAM * DUART * SD/MMC Card Socket Signed-off-by: Otavio Salvador Tested-by: Fabio Estevam