u-boot.git/board/ge/common/Kconfig, branch master

board: ge: common: add config option for RTC and VPD feature

2020-11-01T14:58:47Z

While this code is being used by all GE platforms its useful to have it behind a config option for hardware bringup of new platforms. Signed-off-by: Sebastian Reichel

board: ge: bx50v3, imx53ppd: use DM I2C

2020-02-09T20:47:20Z

Remove old (pre-DM) i2c setup code. Enable DM i2c. Convert common code to use DM rtc. Convert common code to read VPD from eeprom partition. Convert the generic i2c PMIC init code to use the new da9063 driver. mx53ppd only: Correct RTC compatible in device tree. Enable MXC DM i2c driver. Define CONFIG_SYS_MALLOC_F_LEN so that DM is available in pre-reloc. Make GPIO banks available during preloc, since initialisation is done in board_early_init_f(). Add gpio_request() calls to satisfy the DM_GPIO compatibility API. Remove unused power configuration. Signed-off-by: Robert Beckett Signed-off-by: Ian Ray

board: ge: Move VPD EEPROM configuration to the defconfig

2018-12-17T09:46:04Z

Use standard configuration logic to define EEPROM constants. Names are based on VPD_EEPROM_ prefix because EEPROM_ is already used by i2c_eeprom driver. Signed-off-by: Denis Zalevskiy Signed-off-by: Fabien Lahoudere