u-boot.git/board/mpc8540eval/mpc8540eval.c, branch v2009.11.1

fsl_dma: Break out common memory initialization function

2009-07-02T04:12:01Z

Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

8xxx: Move dma_init() call to common code

2009-07-02T04:12:00Z

Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

8xxx: Rename dma_xfer() to dmacpy()

2009-07-02T04:07:47Z

Also update dmacpy()'s argument order to match memcpy's and use phys_addr_t/phy_size_t for address/size arguments Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

85xx: Fix compile breakage with MPC8540EVAL

2009-01-28T20:01:52Z

Configuring for MPC8540EVAL board... mpc8540eval.c: In function 'checkboard': mpc8540eval.c:53: error: invalid operands to binary / make[1]: *** [mpc8540eval.o] Error 1 Signed-off-by: Kumar Gala

mpc8xxx: LCRR[CLKDIV] is sometimes five bits

2008-12-20T00:20:25Z

On newer CPUs, 8536, 8572, and 8610, the CLKDIV field of LCRR is five bits instead of four. In order to avoid an ifdef, LCRR_CLKDIV is set to 0x1f on all systems. It should be safe as the fifth bit was defined as reserved and set to 0. Code that was using a hard coded 0x0f is changed to use LCRR_CLKDIV. Signed-off-by: Trent Piepho Acked-by: Kumar Gala Acked-by: Jon Loeliger

Cleanup: fix "MHz" spelling

2008-10-21T09:25:39Z

Signed-off-by: Wolfgang Denk

rename CFG_ macros to CONFIG_SYS

2008-10-18T19:54:03Z

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD

Moved initialization of TULIP Ethernet controller to board_eth_init()

2008-09-03T04:18:18Z

Affected boards: cu824 bab7xx adciop dasa_sim mousse mpc8540eval musenki mvblue pcippc2/pcippc6 sbc8240 stxssa Removed initialization of the driver from net/eth.c Signed-off-by: Ben Warren

FSL DDR: Convert MPC8540EVAL to new DDR code.

2008-08-27T16:43:52Z

Signed-off-by: Kumar Gala

Change initdram() return type to phys_size_t

2008-06-12T06:50:18Z

This patch changes the return type of initdram() from long int to phys_size_t. This is required for a couple of reasons: long int limits the amount of dram to 2GB, and u-boot in general is moving over to phys_size_t to represent the size of physical memory. phys_size_t is defined as an unsigned long on almost all current platforms. This patch *only* changes the return type of the initdram function (in include/common.h, as well as in each board's implementation of initdram). It does not actually modify the code inside the function on any of the platforms; platforms which wish to support more than 2GB of DRAM will need to modify their initdram() function code. Build tested with MAKEALL for ppc, arm, mips, mips-el. Booted on powerpc MPC8641HPCN. Signed-off-by: Becky Bruce