u-boot.git/board/mscc, branch v2019.04

MSCC: Fix Jaguar2 board detection.

2019-02-01T13:09:31Z

When power cycle the Jaguar2 boards, it couldn't read the phys, therefore it always deduce that the board type is pcb111. Add a small delay after setting the gpio pins, fix the issue. Signed-off-by: Horatiu Vultur

MSCC: Jaguar2 enable debug uart

2019-02-01T13:08:54Z

Enable debug uart for Jaguar2 SoC family. Signed-off-by: Horatiu Vultur

MSCC: Add board support for Serval SoC family.

2019-01-23T17:28:09Z

Add board support and configuration for Jaguar2 SoC family. The detection of the board type is based on the phy ids. Signed-off-by: Horatiu Vultur Reviewed-by: Daniel Schwierzeck

MSCC: Add board support for Servalt SoC family

2019-01-23T17:27:26Z

Add board support, configuration and DTS for Servalt SoC family. Currently there is one board in this family. Reviewed-by: Daniel Schwierzeck Signed-off-by: Horatiu Vultur

MIPS: mscc: ocelot: add switch reset support

2019-01-23T17:26:44Z

On some ocelots platform a workaround is needed in order to be able to reset the switch without resetting the DDR. Signed-off-by: Gregory CLEMENT

MSCC: Add board support for Jaguar2 SOC family

2019-01-16T12:56:43Z

Add board support and configuration for Jaguar2 SOC family. The detection of the board type in this family is based on the phy ids. Signed-off-by: Horatiu Vultur

mips: ocelot: Enable use of serial gpio for LED

2019-01-16T12:56:43Z

This enables the use of the MSCC serial GPIO driver to control the LEDs on the MSCC VCoreIII 'ocelot' pcb123 and pcb120. Signed-off-by: Lars Povlsen

mips: luton: Enable use of serial gpio for LED

2019-01-16T12:56:43Z

This enables the use of the MSCC serial GPIO driver to control the LEDs on the MSCC VCoreIII 'luton' SoC. Signed-off-by: Lars Povlsen

mips: mscc: luton+ocelot: Remove board config options, do probing

2019-01-16T12:56:43Z

As we are moving to multi-dtb and board detection, remove static board config options, and introduce board probing instead. Luton: This add single-binary support for the two MSCC luton-based reference boards - pcb090 and pcb091. The SoC chip ID is used to determine the board type. Ocelot: This add single-binary support for the two MSCC ocelot-based reference boards - pcb120 and pcb123. The PHY ids on specific ports are used to determine the board type. Signed-off-by: Lars Povlsen

MSCC: add board support for the Luton based evaluation board

2018-12-19T14:23:01Z

Adding the support for the Luton boards PCB91 which share common code with the Ocelots boards, including board code, device tree and configuration. Signed-off-by: Gregory CLEMENT