u-boot.git/board/nvidia/dalmore, branch v2014.01

board: arm: convert makefiles to Kbuild style

2013-11-01T15:42:12Z

Signed-off-by: Masahiro Yamada Cc: Albert ARIBAUD Cc: Andreas Bießmann Cc: Stefano Babic Cc: Prafulla Wadaskar Cc: Minkyu Kang Cc: Vipin Kumar Cc: Tom Warren Cc: Tom Rini

Tegra114: MMC: Add SD bus power-rail init routine

2013-03-25T16:56:07Z

T114 requires SD bus power-rail bringup for the SDIO card on SDMMC3. Signed-off-by: Tom Warren Reviewed-by: Stephen Warren

Tegra114: Dalmore: Add SDIO3 pad config to pinctrl_config table

2013-03-25T16:56:07Z

SDIO1 (the SD-card slot on Dalmore) needs to have its pads setup before the MMC driver is added. Signed-off-by: Tom Warren Reviewed-by: Stephen Warren

Tegra114: Dalmore: Add pad config tables/code based on pinmux code

2013-03-14T18:49:14Z

Pad config registers exist in APB_MISC_GP space, and control slew rate, drive strengh, schmidt, high-speed, and low-power modes for all of the pingroups in Tegra30. This builds off of the pinmux way of constructing init tables to configure select pads (SDIOCFG, for instance) during pinmux_init(). Currently, no padcfg entries exist. SDIO3CFG will be added when the MMC driver is added as per the TRM to work with the SD-card slot on Dalmore E1611. Signed-off-by: Tom Warren Reviewed-by: Stephen Warren

Tegra114: Dalmore: Always use DEFAULT instead of DISABLE for lock bits

2013-03-14T18:48:55Z

The pinmux code issues a warning if the caller attempts to disable the lock bit in a pinmux register, since this is impossible (once it's locked, the only way to unlock it is to reset the device/pmt controller). The I2C/DDC/CEC/USB macros expect a lock setting to be passed in, and the previous setting of DISABLE caused the pinmux table parsing code to issue the warning. Changing the lock bits in these table entries to DEFAULT (i.e. don't touch it) fixes this. Signed-off-by: Tom Warren Reviewed-by: Stephen Warren

Tegra114: pinmux: Update pinmux tables & code, fix a bug w/SDMMC3 init

2013-03-14T18:06:43Z

Use the latest tables & code from our internal U-Boot repo. The SDMMC3_CD, CLK_LB_IN and CLK_LB_OUT offsets in the pingroup table were off by a few indices, causing the pinmux init code to write bad data to the PINMUX_AUX_ regs. This also enabled the lock bit, which made it impossible to reconfig the pads correctly for SDMMC3 (SD card on Dalmore) operation. Also fixes SPI_CS2_N, USB_VBUS_EN0, HDMI_CEC and UART2_RXD/TXD muxes. Signed-off-by: Tom Warren Reviewed-by: Stephen Warren

Tegra114: Add/enable Dalmore build (T114 reference board)

2013-02-11T17:35:26Z

This build is stripped down. It boots to the command prompt. GPIO is the only peripheral supported. Others TBD. Signed-off-by: Tom Warren