u-boot.git/board/phytec/pfla02/Kconfig, branch master

arm: Remove pfla02 board

2021-04-10T12:03:30Z

This board has not been converted to CONFIG_DM_MMC by the deadline. Remove it. Cc: Stefano Babic Signed-off-by: Tom Rini

pfla02: Fix RAM detection and support 1 bank SOM

2017-08-29T07:46:32Z

In case of 2 banks, the address space of the first CS must be defined and not let to the higher value. Add support for SOM with a single bank of RAM. It was tested with i.MX6Q modules in the following configurations: - 2 Banks, 4 GB - 2 Banks, 1 GB - 1 Bank, 1 GB Signed-off-by: Stefano Babic

mx6: Add support for Phytec pfla02 (NAND)

2017-08-02T09:45:27Z

Add support for Phytec pfla02, equipped with NAND. CPU: Freescale i.MX6Q rev1.5 996 MHz (running at 792 MHz) CPU: Automotive temperature grade (-40C to 125C) at 31C Reset cause: POR I2C: ready DRAM: 1 GiB NAND: 2048 MiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 SF: Detected n25q128 with page size 256 Bytes, erase size 64 KiB, total 16 MiB In: serial Out: serial Err: serial Net: FEC [PRIME] Hit any key to stop autoboot: 0 Signed-off-by: Stefano Babic CC: Stefan Christ CC: Stefan Müller-Klieser CC: Christian Hemp