u-boot.git/board/phytec, branch v2020.01-rc2

imx: initialize fec only when enabled

2019-10-08T14:36:37Z

board early initialize fec ethernet controller pinmux only when FEC is enabled Signed-off-by: Parthiban Nallathambi Reviewed-by: Peng Fan

imx: remove board specific boot order from spl

2019-10-08T14:36:37Z

boot order was added to handle both SD and eMMC. But commit 14d319b1 introduced to handle both eMMC and SD globally. Signed-off-by: Parthiban Nallathambi Reviewed-by: Peng Fan

imx: pcl063: add nand boot support

2019-10-08T14:36:37Z

Booting from NAND needs nandbcb and nand boot device selection Signed-off-by: Parthiban Nallathambi Reviewed-by: Peng Fan

imx: bk4: Print proper HW revision of VF610's BK4 board

2019-10-08T14:35:59Z

This code uses HW difference on the USB_RESET pin (added PULL UP resistor on the L333 rev) to distinguish between two BK4 HW revisions. Signed-off-by: Lukasz Majewski

env: Rename environment.h to env_internal.h

2019-08-11T23:27:31Z

This file contains lots of internal details about the environment. Most code can include env.h instead, calling the functions there as needed. Rename this file and add a comment at the top to indicate its internal nature. Signed-off-by: Simon Glass Acked-by: Joe Hershberger Reviewed-by: Simon Goldschmidt [trini: Fixup apalis-tk1.c] Signed-off-by: Tom Rini

env: Drop environment.h header file where not needed

2019-08-11T20:43:41Z

This header file is now only used by files that access internal environment features. Drop it from various places where it is not needed. Acked-by: Joe Hershberger Signed-off-by: Simon Glass

env: Move get/set_default_env() to env.h

2019-08-11T20:43:41Z

Move these functions to the new header file and rename set_default_env() to env_set_default() so that it has a consistent env_ prefix. Acked-by: Joe Hershberger Signed-off-by: Simon Glass

env: Move env_set() to env.h

2019-08-11T20:43:41Z

Move env_set() over to the new header file. Acked-by: Joe Hershberger Signed-off-by: Simon Glass

rockchip: rk3288: Move rk3288_detect_reset_reason to soc file

2019-07-29T02:27:45Z

The rk3288_detect_reset_reason() is per-SoC operation, move it to rk3288.c, and extend the rk_board_late_init() with rk3288_board_late_init() to make all the board works fine as before. Signed-off-by: Kever Yang

rockchip: rk3288-phycore: move phycore_init() to its own board file

2019-07-29T02:25:27Z

phycore_init() is use for phycore board only, it should be move back to phycore-rk3288.c Signed-off-by: Kever Yang