u-boot.git/board/phytec, branch v2021.10

Rename SPL_POWER_SUPPORT to SPL_POWER

2021-07-28T18:27:54Z

Rename this option so that CONFIG_IS_ENABLED can be used with it. Signed-off-by: Simon Glass Reviewed-by: Jaehoon Chung

board: phytec: imx8mp-phycore: Switch to binman

2021-07-10T14:53:34Z

Use now binman for image creation. Signed-off-by: Teresa Remmet Reviewed-by: Fabio Estevam Reviewed-by: Heiko Schocher

board: phytec: phycore-imx8mp: Enable DVS1 control

2021-07-10T14:53:34Z

Enable DVS1 control through PMIC_STBY_REQ. Signed-off-by: Teresa Remmet Reviewed-by: Fabio Estevam

board: phytec: phycore_imx8mp: Set VDD_ARM to 0,95V

2021-07-10T14:53:34Z

Increase VDD_ARM to prevent timing issues as VDD_SOC is used in OD mode. Also increase GIC clock. Signed-off-by: Teresa Remmet Reviewed-by: Fabio Estevam

board: phytec: phycore_imx8mp: Add fec support

2021-07-10T14:53:34Z

Enable support for the fec ethernet on phyCORE-i.MX8MP. Signed-off-by: Teresa Remmet Reviewed-by: Fabio Estevam Reviewed-by: Heiko Schocher

board: phytec: phycore_imx8mp: Change debug UART

2021-07-10T14:53:34Z

With the first redesign the debug UART had changed from UART2 to UART1. As the first hardware revision is considered as alpha and will not be supported in future. The old setup will not be preserved. Signed-off-by: Teresa Remmet Reviewed-by: Fabio Estevam Reviewed-by: Heiko Schocher

arm: Remove pfla02 board

2021-04-10T12:03:30Z

This board has not been converted to CONFIG_DM_MMC by the deadline. Remove it. Cc: Stefano Babic Signed-off-by: Tom Rini

power: pca9450: add a new parameter for power_pca9450_init

2021-04-08T07:18:29Z

Currently PCA9450 might have address 0x25 or 0x35, so let user choose the address. Signed-off-by: Peng Fan Reviewed-by: Jaehoon Chung

common: Drop asm/global_data.h from common header

2021-02-02T20:33:42Z

Move this out of the common header and include it only where needed. In a number of cases this requires adding "struct udevice;" to avoid adding another large header or in other cases replacing / adding missing header files that had been pulled in, very indirectly. Finally, we have a few cases where we did not need to include at all, so remove that include. Signed-off-by: Simon Glass Signed-off-by: Tom Rini

board: phytec: imx8mp: Add PHYTEC phyCORE-i.MX8MP support

2021-01-23T10:30:32Z

Add initial support PHYTEC phyCORE-i.MX8MP SOM. Supported features: - 2GB LPDDR4 RAM - eMMC - external SD - debug UART2 - watchdog Signed-off-by: Teresa Remmet Reviewed-by: Heiko Schocher