u-boot.git/board/sunxi, branch v2016.05

sunxi: Add defconfig and dts file for Orange Pi One SBC

2016-04-12T06:58:03Z

The Orange Pi One SBC, is a stripped down version of the popular Orange Pi PC. The one is a H3 based SBC, with 512M of RAM, micro-sd slot, 1 host usb, 1 otg usb, hdmi and 100Mbit ethernet. The dts is identical to the dts submitted to the upstream kernel. Signed-off-by: Hans de Goede Acked-by: Ian Campbell

sunxi: Add INITIAL_USB_SCAN_DELAY Kconfig option

2016-04-12T06:58:03Z

Some boards have on board usb devices which need longer than the USB spec's 1 second to connect from board powerup. Add a config option which when non 0 adds an extra delay before the first usb bus scan. Signed-off-by: Hans de Goede Acked-by: Ian Campbell

sunxi: Reserve ATF memory space on A64

2016-04-01T07:52:28Z

On the A64 we usually boot with ATF running in EL3. ATF as it is available today resides in the first 16MB of RAM. So we should make sure we reserve that space in our memory maps. Signed-off-by: Alexander Graf Acked-by: Hans de Goede Signed-off-by: Hans de Goede

sunxi: Add Pine64+ support

2016-04-01T07:52:28Z

The Pine64+ is a system based on the Allwinner A64 SoC. It is capable of running AArch64 code and thus is the first of its kind for the sunxi target. This patch adds a defconfig and device tree chunks for it. Signed-off-by: Siarhei Siamashka [agraf: Change patch description] Signed-off-by: Alexander Graf Acked-by: Hans de Goede Signed-off-by: Hans de Goede

sunxi: Add support for Allwinner A64 SoCs

2016-04-01T07:52:28Z

The Allwinner A64 SoC is used in the Pine64. This patch adds all bits necessary to compile U-Boot for it running in AArch64 mode. Unfortunately SPL is not ready yet due to legal problems, so we need to boot using the binary boot0 for now. Signed-off-by: Siarhei Siamashka [agraf: remove SPL code, move to AArch64] Signed-off-by: Alexander Graf Acked-by: Hans de Goede Signed-off-by: Hans de Goede

power: axp818: Add support for FLDOs

2016-03-31T15:03:58Z

The FLDOs on AXP818 PMIC normally provide power to CPUS and USB HSIC PHY on the A83T/H8. Signed-off-by: Chen-Yu Tsai Reviewed-by: Hans de Goede Signed-off-by: Hans de Goede

sunxi: Select CONFIG_OF_BOARD_SETUP from arch/arm/Kconfig

2016-03-23T21:04:13Z

Always select OF_BOARD_SETUP on sunxi, rather then having it in almost all our defconfigs. This also fixes it missing from some recently added defconfigs. This commit also modifies our ft_board_setup() to not cause warnings when CONFIG_VIDEO_DT_SIMPLEFB is not set, since we will now always build it. Signed-off-by: Hans de Goede Acked-by: Ian Campbell

sunxi: Turn satapwr on from board_init

2016-03-23T21:04:13Z

There are 2 reasons for doing this: 1) The main reason for doing this is to move it outside of board/sunxi/ahci.c, so that it can be used on boards which use a usb<->sata chip too; 2) While doing this I realized that doing it from board_init also meant doing it much earlier. Some printf get_timer(0) calls show that the time between board_init() and scsi_init() is more then 600 ms, so we can drop the mdelay(500) While at it also drop the printf("SUNXI SCSI INIT\n") AHCI init is noisy enough by itself. Signed-off-by: Hans de Goede Acked-by: Ian Campbell

sunxi: Fix gmac not working due to cpu_eth_init no longer being called

2016-03-23T21:04:13Z

cpu_eth_init is no longer called for dm enabled eth drivers, this was causing the sunxi gmac eth controller to no longer work in u-boot. This commit fixes this by calling the clock, reset and pinmux setup function from s_init() and enabling the phy power pin (if any) from board_init(). The enabling of phy power cannot be done from s_init because it uses dm and dm is not ready yet at this point. Note that the mdelay is dropped as the phy gets enabled much earlier now, so it is no longer needed. Signed-off-by: Hans de Goede Acked-by: Ian Campbell Tested-by: Karsten Merker Tested-by: Michael Haas

sunxi: Add support for USB vbus pin for USB3

2016-03-23T21:04:13Z

The H3 has USB0 - USB3, add support for having a USB vbus pin for USB3. Signed-off-by: Hans de Goede Acked-by: Ian Campbell