u-boot.git/board/synopsys, branch v2022.04

image: Drop IMAGE_ENABLE_OF_LIBFDT

2021-10-08T19:53:26Z

Add a host Kconfig for OF_LIBFDT. With this we can use CONFIG_IS_ENABLED(OF_LIBFDT) directly in the tools build, so drop the unnecessary indirection. Signed-off-by: Simon Glass Reviewed-by: Alexandru Gagniuc

WS cleanup: remove trailing empty lines

2021-09-30T12:08:56Z

Signed-off-by: Wolfgang Denk

global: Convert simple_strtoul() with decimal to dectoul()

2021-08-02T17:32:14Z

It is a pain to have to specify the value 10 in each call. Add a new dectoul() function and update the code to use it. Signed-off-by: Simon Glass

global: Convert simple_strtoul() with hex to hextoul()

2021-08-02T17:32:14Z

It is a pain to have to specify the value 16 in each call. Add a new hextoul() function and update the code to use it. Add a proper comment to simple_strtoul() while we are here. Signed-off-by: Simon Glass

reset: Remove addr parameter from reset_cpu()

2021-03-02T19:03:02Z

Historically, the reset_cpu() function had an `addr` parameter which was meant to pass in an address of the reset vector location, where the CPU should reset to. This feature is no longer used anywhere in U-Boot as all reset_cpu() implementations now ignore the passed value. Generic code has been added which always calls reset_cpu() with `0` which means this feature can no longer be used easily anyway. Over time, many implementations seem to have "misunderstood" the existence of this parameter as a way to customize/parameterize the reset (e.g. COLD vs WARM resets). As this is not properly supported, the code will almost always not do what it is intended to (because all call-sites just call reset_cpu() with 0). To avoid confusion and to clean up the codebase from unused left-overs of the past, remove the `addr` parameter entirely. Code which intends to support different kinds of resets should be rewritten as a sysreset driver instead. This transformation was done with the following coccinelle patch: @@ expression argvalue; @@ - reset_cpu(argvalue) + reset_cpu() @@ identifier argname; type argtype; @@ - reset_cpu(argtype argname) + reset_cpu(void) { ... } Signed-off-by: Harald Seiler Reviewed-by: Simon Glass

common: Drop asm/global_data.h from common header

2021-02-02T20:33:42Z

Move this out of the common header and include it only where needed. In a number of cases this requires adding "struct udevice;" to avoid adding another large header or in other cases replacing / adding missing header files that had been pulled in, very indirectly. Finally, we have a few cases where we did not need to include at all, so remove that include. Signed-off-by: Simon Glass Signed-off-by: Tom Rini

dm: core: Access device ofnode through functions

2021-01-05T19:24:41Z

At present ofnode is present in the device even if it is never used. With of-platdata this field is not used, so can be removed. In preparation for this, change the access to go through inline functions. Signed-off-by: Simon Glass

common: Drop linux/bitops.h from common header

2020-05-19T01:19:23Z

Move this uncommon header out of the common header. Signed-off-by: Simon Glass

common: Drop linux/delay.h from common header

2020-05-19T01:19:23Z

Move this uncommon header out of the common header. Signed-off-by: Simon Glass

common: Drop log.h from common header

2020-05-19T01:19:18Z

Move this header out of the common header. Signed-off-by: Simon Glass