u-boot.git/board/tbs/tbs2910, branch master

global: Move remaining CONFIG_SYS_SDRAM_* to CFG_SYS_SDRAM_*

2022-12-05T21:06:07+00:00

The rest of the unmigrated CONFIG symbols in the CONFIG_SYS_SDRAM
namespace do not easily transition to Kconfig. In many cases they likely
should come from the device tree instead. Move these out of CONFIG
namespace and in to CFG namespace.

Signed-off-by: Tom Rini 
Reviewed-by: Simon Glass

board: tbs2910: Set all board dts files as maintained

2022-10-21T09:54:13+00:00

This also includes the imx6q-tbs2910-u-boot.dtsi file now.

Signed-off-by: Soeren Moch 
Reviewed-by: Fabio Estevam

tbs2910: Convert to DM_SERIAL

2022-04-12T13:36:18+00:00

Conversion to DM_SERIAL is mandatory.

Select DM_SERIAL and add a imx6q-tbs2910-u-boot.dtsi file
that describes the nodes that require dm-pre-reloc, which allows
the DM model to configure the UART pinctrl early.

Remove the now unneeded board UART initialization.

Signed-off-by: Fabio Estevam 
Tested-by: Soeren Moch

imx: Don't define ASSEMBLY in source files

2022-02-09T04:07:58+00:00

This is supposed to be a build-system flag. Move it there so we can
define it before linux/kconfig.h is included.

Signed-off-by: Simon Glass

common: Drop asm/global_data.h from common header

2021-02-02T20:33:42+00:00

Move this out of the common header and include it only where needed.  In
a number of cases this requires adding "struct udevice;" to avoid adding
another large header or in other cases replacing / adding missing header
files that had been pulled in, very indirectly.   Finally, we have a few
cases where we did not need to include  at all, so
remove that include.

Signed-off-by: Simon Glass 
Signed-off-by: Tom Rini

arm: mx6: Make all i.MX6 SoCs user-selectable

2020-08-25T08:26:14+00:00

We have a number of platforms that are a combination of a carrier board
and System-on-Module (SoM) that in turn allows for the board to have
different SoCs on it.  In some cases, this is handled via board-specific
Kconfig options.  In other cases we make use of
CONFIG_SYS_EXTRA_OPTIONS.  This latter case however can lead to invalid
configurations as we will not in turn get options that in Kconfig are
selected by or depend on that setting.

To resolve this, make the SoC option a choice in Kconfig and make boards
depend on what they can support.  This change opens us up for further
clean-ups in the cases where a single CONFIG_TARGET_xxx can support
different SoCs and today they do not, or do not cleanly do so.

Reported-by: Matt Porter 
Cc: Stefano Babic 
Cc: Fabio Estevam 
Cc: "NXP i.MX U-Boot Team" 
Cc: Soeren Moch 
Cc: Markus Niebel 
Cc: Igor Opaniuk 
Cc: Heiko Schocher 
Cc: Hannes Schmelzer 
Cc: Otavio Salvador 
Cc: Nikita Kiryanov 
Cc: Andreas Geisreiter 
Cc: Ludwig Zenz 
Cc: Lukasz Majewski 
Cc: Akshay Bhat 
Cc: Ken Lin 
Cc: Ian Ray 
Cc: Tim Harvey 
Cc: Jagan Teki 
Cc: Raffaele RECALCATI 
Cc: Simone CIANNI 
Cc: Adam Ford 
Cc: Marcin Niestroj 
Cc: "Eric Bénard" 
Cc: Baruch Siach 
Cc: Jason Liu 
Cc: Ye Li 
Cc: Eric Nelson 
Cc: Troy Kisky 
Cc: Peng Fan 
Cc: Parthiban Nallathambi 
Cc: Marek Vasut 
Cc: "Sébastien Szymanski" 
Cc: Christian Gmeiner 
Cc: Niel Fourie 
Cc: Martyn Welch 
Cc: Richard Hu 
Cc: Stefan Roese 
Cc: Boris Brezillon 
Cc: Arkadiusz Karas 
Cc: Breno Lima 
Cc: Francesco Montefoschi 
Cc: Silvio Fricke 
Tested-by: Matt Porter  [colibri_imx6]
Signed-off-by: Tom Rini 
Reviewed-by: Marcin Niestroj

board: tbs2910: add documentation

2020-06-12T17:17:23+00:00

This documents the u-boot installation procedure and the
hardware in order to get started.

Signed-off-by: Denis 'GNUtoo' Carikli 
[trini: Add MAINTAINERS entry for doc file per Soeren's request]

common: Drop init.h from common header

2020-05-18T21:33:33+00:00

Move this uncommon header out of the common header.

Signed-off-by: Simon Glass

board: tbs2910: Convert eth to driver model

2019-10-13T20:49:11+00:00

So we can remove lots of legacy config code.

Signed-off-by: Soeren Moch

board: tbs2910: Convert pci to driver model