u-boot.git/board/teejet, branch v2013.01

OMAP3: TAM3517: add macros for reading eeprom

2012-12-10T15:56:38Z

Added macros to read SOM information from the I2C EEPROM. Signed-off-by: Stefano Babic

OMAP3: fix panel timing on the mt_ventoux board

2012-12-10T15:56:38Z

Signed-off-by: Stefano Babic

OMAP3: mt_ventoux: power on USB at startup

2012-10-25T18:30:49Z

Updated revision of the board uses GPIOs to activate the USB ports. Signed-off-by: Stefano Babic

usb: ehci: rework to take advantage of new lowlevel interface

2012-10-15T18:54:00Z

Kill off ehci-core.h It was used to specify some static controller data. To support more than one controller being active at any time we have to carry the controller data ourselfes. Change the ehci interface accordingly. NOTE: OMAP implemented the ehci stuff a bit backwards and should be fixed to do the same thing as other platforms. But the change for now is at least compile clean. Signed-off-by: Lucas Stach Reviewed-by: Marek Vasut

OMAP3: mt_ventoux: added video support

2012-09-05T00:05:39Z

Signed-off-by: Stefano Babic

OMAP3: mt_ventoux: disable the buzzer at start-up

2012-09-05T00:05:39Z

Signed-off-by: Stefano Babic

OMAP3: mt_ventoux: read MAC address from EEPROM

2012-09-05T00:05:39Z

Signed-off-by: Stefano Babic

OMAP3: mt_ventoux: Correct board pinmux

2012-09-05T00:05:38Z

Fix some issues (some pins were not set as GPIOs) Signed-off-by: Stefano Babic

omap3: Introduce weak misc_init_r

2012-05-15T06:31:28Z

Introduce a __weak misc_init_r function that just runs dieid_num_r(). Remove misc_init_r from cm_t35, mcx, omap3_logic and mt_ventoux as this was all they did for misc_init_r. Cc: Igor Grinberg Cc: Ilya Yanok Cc: Peter Barada Cc: Stefano Babic Signed-off-by: Tom Rini Acked-by: Igor Grinberg

ARM:OMAP+:MMC: Add parameters to MMC init

2012-05-15T06:31:22Z

Add parameters to the OMAP MMC initialization function so the board can mask host capabilities and set the maximum clock frequency. While the OMAP supports a certain set of MMC host capabilities, individual boards may be more restricted and the OMAP may need to be configured to match the board. The PRG_SDMMC1_SPEEDCTRL bit in the OMAP3 is an example. Signed-off-by: Jonathan Solnit