u-boot.git/board/xilinx, branch v2013.10

Coding Style cleanup: remove trailing white space

2013-10-14T20:06:53Z

Signed-off-by: Wolfgang Denk

Merge 'u-boot-microblaze/zynq' into (u-boot-arm/master'

2013-09-03T12:01:02Z

Conflicts: arch/arm/include/asm/arch-zynq/hardware.h The conflict above was trivial and solved during merge.

zynq: Enable axi ethernet and emaclite driver initialization

2013-08-12T06:59:56Z

Zynq can have axi ethernet and emaclite IPs in programmable logic. Signed-off-by: Michal Simek Acked-by: Jagannadha Sutradharudu Teki

zynq: Add new ddrc driver for ECC support

2013-08-12T06:59:55Z

The first 1MB is not initialized by first stage bootloader. Check if memory is setup to 16bit mode and ECC is enabled. If it is, clear the first 1MB. Also u-boot should report only the half size of memory. Acked-by: Jagannadha Sutradharudu Teki Signed-off-by: Michal Simek

fpga: zynqpl: Add support for zc7100 device.

2013-08-12T06:01:50Z

- Add support for zc7100 device. - FPGA programming on few of the SOC(zc7100) takes more than 1sec, hence increased the program time by 4sec to sync' all soc's. Signed-off-by: Jagannadha Sutradharudu Teki Signed-off-by: Michal Simek

xilinx: move microblaze-generic .dts to standard location

2013-08-02T22:29:32Z

Aside from microblaze, all other SoCs/boards/vendors store their DT files in board/$vendor/dts/$soc-$board.dts. Move microblaze-generic.dts to this location for consistency. Signed-off-by: Stephen Warren Acked-by: Simon Glass Acked-by: Michal Simek

Add GPL-2.0+ SPDX-License-Identifier to source files

2013-07-24T13:44:38Z

Signed-off-by: Wolfgang Denk [trini: Fixup common/cmd_io.c] Signed-off-by: Tom Rini

Merge branch 'u-boot/master' into 'u-boot-arm/master'

2013-05-30T12:45:06Z

Conflicts: common/cmd_fpga.c drivers/usb/host/ohci-at91.c

Merge branch 'u-boot-pxa/master' into 'u-boot-arm/master'

2013-05-10T22:06:03Z

gpio: Add support for microblaze xilinx GPIO

2013-05-09T09:20:08Z

Microblaze uses gpio which is connected to the system reset. Currently gpio subsystem wasn't used for it. Add gpio driver and change Microblaze reset logic to be done via gpio subsystem. There are various configurations which Microblaze can have that's why gpio_alloc/gpio_alloc_dual(for dual channel) function has been introduced and gpio can be allocated dynamically. Adding several gpios IP is also possible and supported. For listing gpio configuration please use "gpio status" command This patch also remove one compilation warning: microblaze-generic.c: In function 'do_reset': microblaze-generic.c:38:47: warning: operation on '*1073741824u' may be undefined [-Wsequence-point] Signed-off-by: Michal Simek