Including netdev.h is causing compilation warning:
+ int fecmxc_register_mii_postcall(struct eth_device *dev, int
(*cb)(int));
+                                         ^
w+In file included from ../board/xilinx/zynqmp/zynqmp.c:9:0:
w+../include/netdev.h:204:41: warning: ‘struct eth_device’ declared
inside parameter list [enabled by default]
w+../include/netdev.h:204:41: warning: its scope is only this definition
or declaration, which is probably not what you want [enabled by default]

This patch removes it.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

Define u64 types to be usable on 32bit system because of 64bit address
and size cells and 32bit shifts in the code.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

This is example how to change u-boot to support more memory banks read
from DT.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

Initial Ceva Sata init code.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Reviewed-by: Tom Rini <trini@konsulko.com>

Handle all Xilinx ZynqMP boards with one fragment.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

Read information about memory from DT. This patch simplify life with
synchronization between DT and board files.

dram_init() only needs maximum RAM size below 4GB that's why please sort
banks in memory node.
dram_init_banksize() copies memory setup to bi_dram[].
This will avoid reading information from DT twice.

Memory test start/end were changed to DDR location to let memtest still
compiled.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

OF_CONTROL is enabled by default that's why this is dead code.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

There is incorrect setting for USB which didn't work with origin
ps7_init_gpl.X files.
Use default setting for Digilent Zybo projects with HDMI in PL.

Signed-off-by: Michal Simek <monstr@monstr.eu>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

Provide board specific option how to read MAC address from ROM.
Do it in generic way to be reusable by differnet boards.
If this is not enough board specific functions can be created.

Signed-off-by: Joe Hershberger <joe.hershberger@gmail.com> # driver part
Signed-off-by: Michal Simek <monstr@monstr.eu>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

OF_CONTROL is setup by default and memory reading is done via DT. Remove
all config files with memory references.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>