This patch adds support for the kmsupx4 board from Keymile,
based on a Freescale MPC852T CPU

- serial console on SMC1
- 32 MB SDRAM
- 32 MB NOR Flash
- Ethernet over SCC3
- I2C Bitbang

Signed-off-by: Heiko Schocher <hs@denx.de>

renaming the "mgsuvd" board port into "km8xx", because
there come more similar boards from keymile.
Compiling the mgsuvd board with "make mgsuvd_config"
remains.

Signed-off-by: Heiko Schocher <hs@denx.de>

The Nand flash was unable to read and write properly
due to Nand Chip Select (nCE) setup was in reverse
order. Also, increase the Nand time out value to 60.

Signed-off-by: TsiChung Liew <Tsi-Chung.Liew@freescale.com>

This patch fixes a problem spotted by Mikhail Zolotaryov on Sequoia with
the DDR2 configuration to only use one CS (rank). As this code is most
likely copied from the original Sequoia version, this error was copied
as well.

This patch also removes some dead code.

Signed-off-by: Stefan Roese <sr@denx.de>

This patch fixes a problem spotted by Mikhail Zolotaryov on Sequoia with
the DDR2 configuration to only use one CS (rank). As this code is most
likely copied from the original Sequoia version, this error was copied
as well.

Signed-off-by: Stefan Roese <sr@denx.de>

Sequoia board schematics (DES0211_11_SCH_11.pdf, page 5, unit U1D)
specifies that BankSel#1 is not connected, while bootloader memory
configuration is (board/amcc/sequoia/sdram.c):
       mtsdram(DDR0_10, 0x00000300);
i.e. both Chip Selects used - not correct.

If we change to correct value here:
       mtsdram(DDR0_10, 0x00000100);
memory is accessible OK also.

Signed-off-by: Mikhail Zolotaryov <lebon@lebon.org.ua>
Signed-off-by: Stefan Roese <sr@denx.de>

Update CHANEGLOG, fix minor coding style issue.

Signed-off-by: Wolfgang Denk <wd@denx.de>

Read and store OMAP3 die ID in U-Boot environment.

Signed-off-by: Dirk Behme <dirk.behme@googlemail.com>