u-boot.git/board, branch v2009.03-rc1

OMAP3: Pandora: Update pin mux

2009-02-22T17:29:10Z

Clock pin must have input enabled for MMC3 to work. Also enable pull-ups for cmd/data lines to be consistent with remaining MMC host pin setup. Signed-off-by: Grazvydas Ignotas

OMAP3: Add OMAP3 auto detection

2009-02-22T17:29:10Z

This patch adds OMAP3 cpu type auto detection based on OMAP3 register and removes hardcoded values. Signed-off-by: Steve Sakoman Signed-off-by: Dirk Behme

OMAP3: Beagle: Add board revision detection

2009-02-22T17:29:10Z

With BeagleBoard revision C some HW changes are introduced (e.g. PinMUX) which might need different software handling. For this, GPIO pin 171 (GPIO module 6, offset 11) can be used to check for board revision. If this pin is low, we have a rev C board. Else it must be a revision Ax or Bx board. To handle board differences you can call function beagle_get_revision(). E.g.: if (beagle_get_revision()) { /* do special revision C stuff here */ } Signed-off-by: Dirk Behme

OMAP3: Overo: Clean up pin mux and GPIO configuration

2009-02-22T17:29:10Z

* Make Overo GPIO114 an input for touchscreen PENDOWN * Make Overo GPIO144-147 readable * Make Overo EHCI pinmux match beagle rev c setup * Adjust pinmux for SMSC911X network chip support * Remove unnecessary GPIO setup * Fix merge error in Makefile Signed-off-by: Steve Sakoman Signed-off-by: Dirk Behme

davinci: fix implicit declaration of function 'davinci_errata_workarounds'

2009-02-22T16:49:43Z

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD

ARM DaVinci: Add common peripherals and modules enable functions.

2009-02-22T12:42:25Z

Taken all the duplicated code for enabling common modules and apply software workarounds from the board specific code into common functions. Also added comments explaining the workarounds (from TI errata documents) and replaced some numerical bit numbers with more meaningful defines. Signed-off-by: Hugo Villeneuve

Enable Ethernet for Nomadik 8815 Evaluation Kit

2009-02-22T12:40:31Z

This trivially enables Ethernet support in the debug board by setting up the proper chip select. Signed-off-by: Alessandro Rubini Acked-by: Andrea Gallo

Coding Style cleanup; update CHANGELOG

2009-02-22T00:19:52Z

Signed-off-by: Wolfgang Denk

82xx, mgcoge: updates for 2009.03

2009-02-19T20:20:16Z

- activate CS4 for accessing the FPGA - activate Rx buf len > 1 on SMC - pram activated - MTDPARTS_DEFAULT defined - update the size of the flashes in the DTS before booting Linux - MONITOR_LEN updated to 384k - added CONFIG_HOSTNAME - added CONFIG_ENV_BUFFER_PRINT - Environment size reduced to 16k Signed-off-by: Heiko Schocher

8xx, mgsuvd: updates for 2009.03

2009-02-19T20:19:45Z

- activate Rx buf len > 1 on SMC - pram activated - MTDPARTS_DEFAULT defined - update the size of the flash in the DTS before booting Linux - MONITOR_LEN updated to 384k - added CONFIG_HOSTNAME - added CONFIG_ENV_BUFFER_PRINT - Environment size reduced to 16k Signed-off-by: Heiko Schocher