Signed-off-by: Wolfgang Denk <wd@denx.de>

Signed-off-by: Detlev Zundel <dzu@denx.de>

The pin which was used in preliminary versions of the board for ide
reset is really connected to the rtc clock.

Signed-off-by: Detlev Zundel <dzu@denx.de>

Signed-off-by: Detlev Zundel <dzu@denx.de>
Cc: Sascha Hauer <s.hauer@pengutronix.de>

AFEB9260 uses PA10, PA11 for ETX2 and ETX3.
Also, due to extarnal pull-up on IRQ line, Micrel PHY ID is 1 after reset sequence,
not 0.

Signed-off-by: Sergey Lapin <slapin@ossfans.org>

We don't know what state the ethernet PHY is in when starting up, so make
sure we set it to a sane state.  This fixes troubles seen when Linux boots
up, configures the PHY is a non-default state, and then the system reboots
into U-Boot which previously expected a reset state only.

Signed-off-by: Graf Yang <graf.yang@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>

When dropping jump block support, the assumption was that all bootroms
supported entry point redirection via the EVT1 register.  Unfortunately,
this turned out to be incorrect for the oldest Blackfin parts (BF533-0.2
and older and BF561).  No one really noticed earlier because these parts
usually are booted by bypassing the bootrom entirely, and older BF533
parts are not supported at all (too many anomalies).

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

The Beagle Rev C boards pull UART2 from an alternate set of balls.

Signed-off-by: Steve Sakoman <steve@sakoman.com>
Signed-off-by: Dirk Behme <dirk.behme@googlemail.com>

The board-types defined in struct omap3_sysinfo seem to be
unused. The function display_board_info() is passed
board type as an argument; which is ignored.

This patch removes all uses of board-type, related definitions
and functions.

Signed-off-by: Sanjeev Premi <premi@ti.com>