u-boot.git/board, branch v2017.05-rc2

Merge git://git.denx.de/u-boot-rockchip

2017-04-17T02:08:13Z

Merge git://git.denx.de/u-boot-dm

2017-04-17T02:07:52Z

rockchip: ARM64: split RK3399-Q7 board off the RK3399-EVB board

2017-04-15T16:13:17Z

The RK3399-Q7 SoM is a Qseven-compatible (70mm x 70mm, MXM-230 connector) system-on-module from Theobroma Systems, featuring the Rockchip RK3399. It provides the following feature set: * up to 4GB DDR3 * on-module SPI-NOR flash * on-module eMMC (with 8-bit interace) * SD card (on a baseboad) via edge connector * Gigabit Ethernet w/ on-module Micrel KSZ9031 GbE PHY * HDMI/eDP/MIPI displays * 2x MIPI-CSI * USB - 1x USB 3.0 dual-role (direct connection) - 2x USB 3.0 host + 1x USB 2.0 (on-module USB 3.0 hub) * on-module STM32 Cortex-M0 companion controller, implementing: - low-power RTC functionality (ISL1208 emulation) - fan controller (AMC6821 emulation) - USB<->CAN bridge controller Note that we use a multi-payload FIT image for booting and have Cortex-M0 payload in a separate subimage: we thus rely on the FIT image loader to put it into the SRAM region that ATF expects it in. Signed-off-by: Klaus Goger Signed-off-by: Philipp Tomsich Fixed build warning on puma-rk3399: Signed-off-by: Simon Glass Reviewed-by: Simon Glass

board: sama5d3_xplained: Enable early debug UART

2017-04-15T02:10:35Z

Enable the early debug UART to debug problems when an ICE or other debug mechanism is not available. Signed-off-by: Wenyou Yang

board: sama5d3_xplained: Clean up code

2017-04-15T02:10:35Z

Due to the introduction of the pinctrl and clk driver, and using device tree files, remove the unneeded hardcoded pin configuration and clock enabling code from the board file. Signed-off-by: Wenyou Yang

board: sama5d3_xplained: Update to support DM/DT

2017-04-15T02:10:35Z

Update the configuration files to support the device tree and driver model, so do SPL. The device clock and pins configuration are handled by the clock and the pinctrl drivers respectively. Signed-off-by: Wenyou Yang Fix build error with sama5d3_xplained_mmc: Signed-off-by: Simon Glass

board: sama5d3xek: Enable early debug UART

2017-04-15T02:10:35Z

Enable the early debug UART to debug problems when an ICE or other debug mechanism is not available. Signed-off-by: Wenyou Yang

board: sama5d3xek: Clean up code

2017-04-15T02:10:25Z

board: sama5d3xek: Update to support DM/DT

2017-04-15T02:09:28Z

Update the configuration files to support the device tree and driver model, so do SPL. The device clock and pins configuration are handled by the clock and the pinctrl drivers respectively. Signed-off-by: Wenyou Yang Add back CONFIG_PHY_MICREL to prevent a build error: Signed-off-by: Simon Glass

Merge branch 'master' of git://git.denx.de/u-boot-video

2017-04-15T02:05:17Z