Signed-off-by: Mike Frysinger <vapier@gentoo.org>

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

This patch adds a 'cu' like serial terminal command to u-boot
using which you can access other serial ports from the system console.

OpenMoko uses this in their Neo1973 phones to get access to the GSM
Modem and GPS chip from the bootloader.

Signed-off-by: Harald Welte <laforge@openmoko.org>

Modify common/Makefile to conditionally compile fdt_support.c based
on CONFIG_OF_LIBFDT.

Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

Modify common/Makefile to conditionally compile the cmd_*.c files based
on the board config.

Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

This change is in preparation for condtitionial compile support in the
build system.  By spliting them all into seperate lines now, subsequent
patches that change 'COBJS-y += ' into 'COBJS-$(CONFIG_<blah>) += ' will
be less invasive and easier to review

Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

[PATCH 3/3] OneNAND support (take #2)

OneNAND support at U-Boot

Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>

Bridge, ICH-5, ICH-6 and ICH-7. 

Implementation:

1. Code is divided in to two files. All functions, which are
   controller specific are kept in "drivers/ata_piix.c" file and
   functions, which are not controller specific, are kept in
   "common/cmd_sata.c" file.

2. Reading and Writing from the S-ATA drive is done using PIO method.

3. Driver can be configured for 48-bit addressing by defining macro
   CONFIG_LBA48, if this macro is not defined driver uses the 28-bit
   addressing.

4. S-ATA read function is hooked to the File system, commands like
   ext2ls and ext2load file can be used. This has been tested.

5. U-Boot command "SATA_init" is added, which initializes the S-ATA
   controller and identifies the S-ATA drives connected to it.

6. U-Boot command "sata" is added, which is used to read/write, print
   partition table and get info about the drives present. This I have
   implemented in same way as "ide" command is implemented in U-Boot.

7. This driver is for S-ATA in native mode.

8. This driver does not support the Native command queuing and
   Hot-plugging.

Signed-off-by: Mushtaq Khan <mushtaq_k@procsys.com>

Conflicts:

	include/asm-microblaze/microblaze_intc.h
	include/linux/stat.h