u-boot.git/common/Makefile, branch v2012.10-rc1

Merge branch 'ext4'

2012-09-20T18:27:35Z

Update Makefile change for LIBS -> LIBS-y change. Conflicts: Makefile Signed-off-by: Tom Rini

dfu:cmd: Support for DFU u-boot command

2012-09-01T14:21:51Z

Support for u-boot's command line command "dfu [list]". Signed-off-by: Lukasz Majewski Signed-off-by: Kyungmin Park Cc: Marek Vasut

ext4fs ls load support

2012-08-09T21:47:43Z

Signed-off-by: Uma Shankar Signed-off-by: Manjunatha C Achar Signed-off-by: Iqbal Shareef Signed-off-by: Hakgoo Lee

zfs: Add ZFS filesystem support

2012-08-09T21:42:20Z

U-Boot port is based on sources forked from GRUB-0.97 by Sun in 2004, which can be found here: http://src.opensolaris.org/source/xref/onnv/onnv-gate/usr/src/grub/grub-0.97/stage2/zfs-include/zfs.h Released by Sun for GRUB under the license: * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation; either version 2 of the License, or * (at your option) any later version. GRUB official releases include ZFS in version: ftp://alpha.gnu.org/gnu/grub/grub-1.99~rc1.tar.gz And patched against GRUB Bazaar repository for ashift fixes (4KB HDDs) more conveniently found at github: https://github.com/pendor/grub-zfs/commit/e7b6ef3ac3b9685ac4c394c897b1d4221b7381f1 Signed-off-by: Jorgen Lundman

SPL: common/Makefile: Add image.c to SPL build

2012-07-07T12:07:43Z

This is needed for the SPEAr SPL support, as SPEAr uses the mkimage header to wrap and validate the images (SPL & U-Boot). Signed-off-by: Stefan Roese

Block: Remove MG DISK support

2012-06-21T18:53:09Z

This driver is unused and obsolete. Signed-off-by: Marek Vasut Cc: Wolfgang Denk Cc: unsik Kim

powerpc/corenet_ds: Slave reads ENV from master when boot from SRIO

2012-04-25T04:58:33Z

When boot from SRIO, slave's ENV can be stored in master's memory space, then slave can fetch the ENV through SRIO interface. NOTE: Because the slave can not erase, write master's NOR flash by SRIO interface, so it can not modify the ENV parameters stored in master's NOR flash using "saveenv" or other commands. Master needs to: 1. Put the slave's ENV into it's own memory space. 2. Set an inbound SRIO window covered slave's ENV stored in master's memory space. Slave needs to: 1. Set a specific TLB entry in order to fetch ucode and ENV from master. 2. Set a LAW entry with the TargetID SRIO1 or SRIO2 for ucode and ENV. Signed-off-by: Liu Gang Signed-off-by: Shaohui Xie

Add support for loading and saving the environment to a FAT partition

2012-03-30T20:38:14Z

The following must be defined: CONFIG_ENV_IS_IN_FAT Enable this saving environment to FAT. FAT_ENV_INTERFACE Interface the FAT resides on (e.g. mmc). FAT_ENV_DEVICE The interface device number (e.g. 0 for mmc0) FAT_ENV_PART The device part (e.g. 1 for mmc0:1) FAT_ENV_FILE The filename of the environment file. Author: Maximilian Schwerin Removed dead DEBUG comment. Signed-off-by: Wolfgang Denk

Add cmd_spl command

2012-03-27T20:05:28Z

This adds a spl command to the u-boot. Related config: CONFIG_CMD_SPL activate/deactivate the command CONFIG_CMD_SPL_NAND_OFS Offset in NAND to use Signed-off-by: Simon Schwarz Signed-off-by: Stefano Babic CC: Tom Rini CC: Wolfgang Denk

SPL: Add YMODEM over UART load support

2012-03-26T21:09:25Z

Adds support for loading U-Boot from UART using YMODEM protocol. If YMODEM support is enabled in SPL and the romcode indicates that SPL loaded via UART then SPL will wait for start of a YMODEM transfer via the console port. Signed-off-by: Matt Porter Signed-off-by: Tom Rini