u-boot.git/configs/mx53ppd_defconfig, branch v2018.03

bootcount: Migrate CONFIG_SYS_BOOTCOUNT_ADDR

2018-02-25T18:41:54Z

Migrate the users of CONFIG_SYS_BOOTCOUNT_ADDR to Kconfig. We can provide a default for BOOTCOUNT_AM33XX as that's a specific part of the RTC in use. We can also provide a default for ARCH_LS1043A and ARCH_LS1021A as they had been previously calculated and their symbols are in Kconfig. In the case of other QE-enabled platforms, they are not so we must update the relevant defconfig files. The previous default only applied in some cases, even on a specific SoC family. Reviewed-by: Lukasz Majewski Reviewed-by: Alex Kiernan Signed-off-by: Tom Rini

Merge CONFIG_BOOTCOUNT and CONFIG_BOOTCOUNT_LIMIT

2018-02-24T13:43:11Z

CONFIG_BOOTCOUNT was only used in mx53ppd, merge it with CONFIG_BOOTCOUNT_LIMIT Signed-off-by: Alex Kiernan Reviewed-by: Lukasz Majewski Reviewed-by: Ian Ray

Convert CONFIG_BOOTP_BOOTPATH et al to Kconfig

2018-02-24T02:41:49Z

This converts the following to Kconfig: CONFIG_BOOTP_BOOTPATH CONFIG_BOOTP_DNS CONFIG_BOOTP_GATEWAY CONFIG_BOOTP_HOSTNAME CONFIG_BOOTP_PXE CONFIG_BOOTP_SUBNETMASK CONFIG_CMDLINE_EDITING CONFIG_AUTO_COMPLETE CONFIG_SYS_LONGHELP CONFIG_SUPPORT_RAW_INITRD CONFIG_ENV_VARS_UBOOT_CONFIG Signed-off-by: Adam Ford [trini: Re-run the migration] Signed-off-by: Tom Rini

Convert CONFIG_BOOTCOUNT_LIMIT to Kconfig

2018-02-15T12:20:53Z

This converts the following to Kconfig: CONFIG_BOOTCOUNT_LIMIT Signed-off-by: Lukasz Majewski Tested-by: Alex Kiernan Reviewed-by: Hannes Schmelzer Acked-by: Hannes Schmelzer

configs: Migrate CONFIG_SYS_TEXT_BASE

2018-02-11T14:30:09Z

On the NIOS2 and Xtensa architectures, we do not have CONFIG_SYS_TEXT_BASE set. This is a strict migration of the current values into the defconfig and removing them from the headers. I did not attempt to add more default values in and for now will leave that to maintainers. Signed-off-by: Tom Rini

configs: Resync with savedefconfig

2017-12-19T01:19:09Z

Rsync all defconfig files using moveconfig.py Signed-off-by: Tom Rini

mx53: Add Board support for GE PPD

2017-11-20T08:59:02Z

Create board support for GE PPD, based on mx53loco. Use mx53ppd_defconfig make target to configure for this board. Signed-off-by: Peter Senna Tschudin Signed-off-by: Ian Ray Signed-off-by: Nandor Han Signed-off-by: Martyn Welch Cc: Stefano Babic Acked-by: Stefano Babic