u-boot.git/configs/ph1_ld4_defconfig, branch master

ARM: uniphier: merge ph1_ld4_defconfig and ph1_sld8_defconfig

2015-12-22T15:08:57Z

These two are similar enough to be merged into a single defconfig file. Distinguish one from another by "DEVICE_TREE" from the command line. The how-to-build in doc/README.uniphier should be also updated. Signed-off-by: Masahiro Yamada

Reorder defconfigs with 'savedefconfig'

2015-09-28T13:06:13Z

Some boards' defconfigs are disordered. Reorder them. Signed-off-by: Bin Meng

ARM: uniphier: rename CONFIG_MACH_* to CONFIG_ARCH_UNIPHIER_*

2015-09-24T15:27:53Z

I want these prefixed with CONFIG_ARCH_UNIPHIER_ to clarify they belong to UniPhier SoC family. Signed-off-by: Masahiro Yamada

ARM: uniphier: enable setexpr command

2015-09-24T15:27:53Z

This command will be used in the next commit to calculate base-offseted addresses. Signed-off-by: Masahiro Yamada

ARM: uniphier: drop DCC micro support card support

2015-09-24T15:27:52Z

Historically (for compatibility with very old platforms), two different types of micro support cards have been used with the UniPhier SoC development boards. It has been painful to maintain both. Having one of them is enough. Signed-off-by: Masahiro Yamada Reviewed-by: Simon Glass

ARM: uniphier: enable PINCTRL and SPL_PINCTRL

2015-09-24T15:27:52Z

Now, UniPhier SoCs are ready to enable pinctrl drivers. Signed-off-by: Masahiro Yamada

ARM: uniphier: increase CONFIG_SYS_MALLOC_F_LEN to bind all nodes

2015-09-24T15:27:52Z

In the next commit, I will add "u-boot,dm-pre-reloc" to the "soc" (simple-bus) nodes in UniPhier device trees. But, before that, CONFIG_SYS_MALLOC_F_LEN must be increased. Adding "u-boot,dm-pre-reloc" to a simple-bus node causes it to bind all of its child nodes. (See simple_bus_post_bind() function) Actually, I want only UART0 and pinctrl to be bound in SPL and before relocation in U-boot proper. But, with "u-boot,dm-pre-reloc" in the simple-bus node, all the other unwanted nodes are also bound. The default value for CONFIG_SYS_MALLOC_F_LEN, 0x400, is not enough for that. Increase the pre-reloc malloc size to 0x2000, hoping the root cause will be fixed later. Signed-off-by: Masahiro Yamada

ARM: uniphier: enable simple-bus driver for SPL

2015-09-24T15:27:52Z

In UniPhier device trees, pinctrl device nodes are located under the simple-bus (AMBA). This is needed to bind pinctrl devices in SPL. Signed-off-by: Masahiro Yamada

ARM: uniphier: select SPL_DM rather than default in defconfig

2015-08-30T13:20:20Z

Now UniPhier SoCs highly depend on Driver Model for SPL, too. Signed-off-by: Masahiro Yamada

ARM: UniPhier: disable CONFIG_FIT

2015-07-23T14:42:11Z

To use FIT boot, we have to describe Image Tree Source in addition. So, it is not intended for beginners. Disable it by default. Signed-off-by: Masahiro Yamada