Resync all defconfig files using qconfig.py

Signed-off-by: Tom Rini <trini@konsulko.com>

Now that eMMC is working properly on H616 devices, it became apparent
that some boards were missing the right defconfig bits to enable eMMC
access.

Add the eMMC device number to the Tanix TX1 and the X96 Mate defconfig,
also the eMMC boot option to the TX1. Oddly enough the X96 Mate had
just this bit already.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Reviewed-by: Jernej Skrabec <jernej.skrabec@gmail.com>

The H616 DRAM controller requires some board specific parameters, which
we declare in Kconfig, let each board specify in their defconfig, and
then use in the DRAM init code.

Other DRAM controllers now require a very similar, if not identical
parameter set, with so far the same parameter names used.

To help keep the Kconfig file at bay, rename the existing parameter
names to drop the H616_ part in there, to make them more naturally
reusable for other SoCs.

No functional change, just a rename.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Reviewed-by: Jernej Skrabec <jernej.skrabec@gmail.com>

With the recent "old-style sunxi" sync and the penultimate OF_UPSTREAM DT
update, both directories were based on the same v6.10 kernel tree.
And while there is one subtle difference in many Allwinner SoC's DT
files, the H616 ones turn out to be identical.

Remove the old copies of the H616 related .dts and .dtsi files, and
switch the whole H616 SoC over to use OF_UPSTREAM. This immediately
benefits from the recent upstream DT update, to kernel v6.11.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>

The Tanix TX1 is a tiny TV box, featuring the Allwinner H313 SoC with up
to 2GB of DRAM and 16GB of eMMC. There is no SD card or Ethernet port on
this small device, but it can be booted via the USB debug "FEL" mode.
The bootloader could then be written to the eMMC.

Add the defconfig for that board, and add the devicetree file to the
Makefile, for it to be built.
The DRAM parameters were taken from the vendor firmware on the eMMC.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>