u-boot.git/cpu/arm926ejs/nomadik, branch v2009.08

arm nomadik: add gpio support

2009-07-29T07:57:46Z

Signed-off-by: Alessandro Rubini Acked-by: Andrea Gallo Acked-by: Jean-Christophe PLAGNIOL-VILLARD

arm nomadik: use 1000 as HZ value and rewrite timer code

2009-07-06T19:53:08Z

This sets CONFIG_SYS_HZ to 1000 as required, and completely rewrites timer code, which is now both correct and much smaller. Unused functions like udelay_masked() have been removed as no driver uses them, even the ones that are not currently active for this board. mtu.h is copied literally from the kernel sources. Signed-off-by: Alessandro Rubini Acked-by: Andrea Gallo Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD

arm nomadik: cleanup reset

2009-07-06T19:53:03Z

There is only one public release of the Nomadik chip, so the ifdef in reset code as well as a define in the config file are not needed Signed-off-by: Alessandro Rubini Acked-by: Andrea Gallo

arm920/926/926: remove non needed header

2009-06-12T18:39:49Z

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD

Fix e-mail address of Gary Jennejohn.

2009-05-15T20:11:59Z

Signed-off-by: Detlev Zundel

Initial support for Nomadik 8815 development board

2009-01-24T17:10:37Z

The NMDK8815 board is distributed by ST Microelectornics. Other (proprietary) code must be run to unlock the CPU before U-Boot runs. doc/README.nmdk8815 outlines the boot sequence. This is the initial port, with basic infrastructure and a working serial port. Signed-off-by: Alessandro Rubini Acked-by: Andrea Gallo Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD