u-boot.git/cpu/mpc85xx, branch v2009.08-rc2

Update Freescale copyrights to remove "All Rights Reserved"

2009-07-29T07:59:22Z

fsl_dma: Break out common memory initialization function

2009-07-02T04:12:01Z

Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

8xxx: Move dma_init() call to common code

2009-07-02T04:12:00Z

Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

fsl_dma: Move dma function prototypes to common header file

2009-07-02T04:11:52Z

Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

8xxx: Rename dma_xfer() to dmacpy()

2009-07-02T04:07:47Z

Also update dmacpy()'s argument order to match memcpy's and use phys_addr_t/phy_size_t for address/size arguments Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

8xxx: Break out DMA code to a common file

2009-07-02T04:01:51Z

DMA support is now enabled via the CONFIG_FSL_DMA define instead of the previous CONFIG_DDR_ECC Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

fsl/85xx, 86xx: Sync up DMA code

2009-06-12T22:17:58Z

The following changes were made to sync up the DMA code between the 85xx and 86xx architectures which will make it easier to break out common 8xxx DMA code: 85xx: - Don't set STRANSINT and SPCIORDER fields in SATR register. These bits only have an affect when the SBPATMU bit is set. - Write 0xffffffff instead of 0xfffffff to clear errors in the DMA status register. We may as well clear all 32 bits of the register... 86xx: - Add CONFIG_SYS_MPC86xx_DMA_ADDR define to address DMA registers - Add clearing of errors in the DMA status register when initializing the controller - Clear the channel start bit in the DMA mode register after a transfer Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

fsl: Create common fsl_dma.h for 85xx and 86xx cpus

2009-06-12T22:17:45Z

Break out DMA structures for the Freescale MPC85xx and MPC86xx cpus to reduce a large amount of code duplication Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala

qe: Pass in uec_info struct through uec_initialize

2009-06-12T22:17:02Z

The uec driver contains code to hard code configuration information for the uec ethernet controllers. This patch creates an array of uec_info structures, which are then parsed by the corresponding driver instance to determine configuration. It also creates function uec_standard_init() to initialize all UEC interfaces for 83xx and 85xx. Signed-off-by: Haiying Wang Signed-off-by: Kumar Gala

85xx: Add QE clk support

2009-06-12T22:16:59Z

Signed-off-by: Haiying Wang Acked-by: Timur Tabi Signed-off-by: Kumar Gala