u-boot.git/cpu/pxa/serial.c, branch master

pxa: move serial driver to drivers/serial

2009-06-12T18:39:52+00:00

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD

fix pxa255_idp board

2007-10-23T14:40:40+00:00

The pxa255_idp being an old unmaintained board showed several issues:
1. CONFIG_INIT_CRITICAL was still defined.
2. Neither CONFIG_MAC_PARTITION nor CONFIG_DOS_PARTITION was defined.
3. Symbol flash_addr was undeclared.
4. The boards lowlevel_init function was still called memsetup.
5. The TEXT_BASE was still 0xa3000000 rather than 0xa3080000.
6. Using -march=armv5 instead of -march=armv5te resulted in lots of
'target CPU does not support interworking' warnings on recent compilers.
7. The PXA's serial driver redefined FFUART, BTUART and STUART used as
indexes rather than the register definitions from the pxa-regs header
file. Renamed them to FFUART_INDEX, BTUART_INDEX and STUART_INDEX to
avoid any ambiguities.
8. There were several redefinition warnings concerning ICMR, OSMR3,
OSCR, OWER, OIER, RCSR and CCCR in the PXA's assembly start file.
9. The board configuration file was rather outdated.
10. The part header file defined the vendor, product and revision arrays
as unsigned chars instead of just chars in the block_dev_desc_t
structure.

Signed-off-by: Marcel Ziswiler

PXA270: Add support for multiple serial ports.

2007-09-06T23:04:59+00:00

This patch adds support for multiple serial ports to the PXA target.
FFUART, BTUART and STUART are supported.

Signed-off-by: Stefano Babic

GCC-4.x fixes: clean up global data pointer initialization for all boards.

2006-03-31T16:32:53+00:00

This is the first commit for the u-boot zylonite port. The following has be

2006-02-07T19:04:48+00:00

done so far:

	* created zylonite board dir (based on lubbock)
	* extended some - but not all pxa sources and headers for Intel
	  Monahans support (CONFIG_CPU_MONAHANS)
	* created Makefile zylonite target + MAKEALL entry
	* added some debug nonsense, remove later, grep for mk@tbd

Status: compiles (eldk-4.0), and can be started with BDI, but runs forever
	and doesn't halt at breakpoints. Hmmm...

* Patches by Anders Larsen, 17 Sep 2003:

2003-09-18T09:21:33+00:00

  - fix spelling errors
  - set GD_FLG_DEVINIT flag only after device function pointers
    are valid
  - Allow CFG_ALT_MEMTEST on systems where address zero isn't
    writeable
  - enable 3.rd UART (ST-UART) on PXA(XScale) CPUs
  - trigger watchdog while waiting in serial driver

Patch by Kyle Harris, 20 May 2003:

2003-05-23T12:36:20+00:00

In preparation for an ixp port, rename cpu/xscale and arch-xscale
into cpu/pxa and arch-pxa.