Signed-off-by: Wolfgang Denk <wd@denx.de>

- convert frame size settings to be derived from a single base
- set frame size to the recommended default value

Signed-off-by: Grzegorz Bernacki <gjb@semihalf.com>

Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>

- correct configuration space mapping
- correct bus numbering
- better access to config space

Prior to this patch, the 440SPe host/PCIe bridge was able to configure only the
first device on the first bus. We now allow to configure up to 16 buses;
also, scanning for devices behind the PCIe-PCIe bridge is supported, so
peripheral devices farther in hierarchy can be identified.

Signed-off-by: Grzegorz Bernacki <gjb@semihalf.com>

Convert using fixup mechanism to suppressing MCK for the duration of config
read/write transaction: while fixups work fine with the case of a precise
exception, we identified a major drawback with this approach when there's
an imprecise case. In this scenario there is the following race condition:
the fixup is (by design) set to catch the instruction following the one
actually causing the exception; if an interrupt (e.g. decrementer) happens
between those two instructions, the ISR code is executed before the fixup
handler the machine check is no longer protected by the fixup handler as it
appears as within the ISR code. In consequence the fixup approach is being
phased out and replaced with explicit suppressing of MCK during a PCIe
config read/write cycle.

Signed-off-by: Grzegorz Bernacki <gjb@semihalf.com>

When frame larger than local RX buffer is received, it is split and handled
by two buffer descriptors. Prior to this patch the FEC driver discarded
contents of a buffer descriptor without the 'LAST' bit set, so the first
part of the frame was lost in case of larger frames. This fix allows to
safely combine the two pieces into the whole frame.

Signed-off-by: Grzegorz Bernacki <gjb@semihalf.com>

Signed-off-by: Rafal Jaworowski <raj@semihalf.com>

This patch adds support for multiple serial ports to the PXA target.
FFUART, BTUART and STUART are supported.

Signed-off-by: Stefano Babic <sbabic@denx.de>