u-boot.git/disk/part.c, branch v2012.07

Block: Remove MG DISK support

2012-06-21T18:53:09+00:00

This driver is unused and obsolete.

Signed-off-by: Marek Vasut 
Cc: Wolfgang Denk 
Cc: unsik Kim

disk/part.c: Fix device enumeration through API

2012-03-27T09:46:33+00:00

The patch below fixes device enumeration through the U-Boot API.

Device enumeration crashes when the system in question doesn't
have any RAM mapped to address zero (I discovered this on a
BeagleBone board), since the enumeration calls get_dev with a
NULL ifname sometimes which then gets passed down to strncmp().

This fix simply ensures that get_dev returns NULL when invoked
with a NULL ifname.

Signed-off-by: Tim Kientzle 
Signed-off-by: Anatolij Gustschin

disk/part.c: fix potential stack overflow bug

2011-04-12T20:58:35+00:00

If the param pass to get_dev is not the one defined in the block_drvr,
it could make uboot becomes unstable, for it would continue run after
search complete the block_drvr table.

Signed-off-by: Lei Wen

Replace CONFIG_RELOC_FIXUP_WORKS by CONFIG_NEEDS_MANUAL_RELOC

2010-10-29T19:32:07+00:00

By now, the majority of architectures have working relocation
support, so the few remaining architectures have become exceptions.
To make this more obvious, we make working relocation now the default
case, and flag the remaining cases with CONFIG_NEEDS_MANUAL_RELOC.

Signed-off-by: Wolfgang Denk 
Tested-by: Heiko Schocher 
Tested-by: Reinhard Meyer

disk/part.c: fix relocation fixup

2010-09-19T17:29:52+00:00

Portions of this work were supported by funding from
the CE Linux Forum.

Signed-off-by: Heiko Schocher

mmc: print out partition table

2010-09-18T21:47:28+00:00

Signed-off-by: Lei Wen

disk/part.c: 'usb storage' avoiding overflow when output capacity

2010-08-10T21:08:55+00:00

Before:
    Marvell>> usb storage
      Device 0: Vendor: StoreJet Rev:  Prod:  Transcend
                Type: Hard Disk
                Capacity: 28759.9 MB = 28.0 GB (488397168 x 512)
After:
    Marvell>> usb storage
      Device 0: Vendor: StoreJet Rev:  Prod:  Transcend
                Type: Hard Disk
                Capacity: 238475.1 MB = 232.8 GB (488397168 x 512)

Signed-off-by: Sergei Trofimovich

common: delete CONFIG_SYS_64BIT_VSPRINTF and CONFIG_SYS_64BIT_STRTOUL

2009-12-08T21:14:07+00:00

There is more and more usage of printing 64bit values,
so enable this feature generally, and delete the
CONFIG_SYS_64BIT_VSPRINTF and CONFIG_SYS_64BIT_STRTOUL
defines.

Signed-off-by: Heiko Schocher

Conditionally perform common relocation fixups

2009-10-03T08:17:57+00:00

Add #ifdefs where necessary to not perform relocation fixups.  This
allows boards/architectures which support relocation to trim a decent
chunk of code.

Note that this patch doesn't add #ifdefs to architecture-specific code
which does not support relocation.

Signed-off-by: Peter Tyser

IDE: bail out of dev_print() for unknown device types

2009-05-15T20:30:13+00:00

Commit 574b319512 introduced a subtle bug by mixing a list of tests
for "dev_desc->type" and "dev_desc->if_type" into one switch(), which
then mostly did not work because "dev_desc->type" cannot take any
"IF_*" type values. A later fix in commit 8ec6e332ea changed the
switch() into testing "dev_desc->if_type", but at this point the
initial test for unknown device types was completely lost, which
resulted in output like that for IDE ports without device attached:

  Device 1: Model:  Firm:  Ser#:
            Type: # 1F #
            Capacity: not available

This patch re-introduces the missing test for unknown device types.

Signed-off-by: Wolfgang Denk 
Cc: Stefan Roese 
Cc: Detlev Zundel 
Tested-by: Stefan Roese